Integra RDV-1.1 Connecting a Component with an Hdmi Output, Connecting Components with

Connecting—Continued

P.Connecting a Component with an HDMI Output

The RDV-1.1 has an HDMI IN socket, so you can con- nect another HDMI-compatible component, such as an AV receiver. When the video input source on the RDV-1.1 is set HDMI (see page 67), signals received by the HDMI IN are fed through to the HDMI OUT.

RS 232	HDMI	VIDEO IN	VIDEO OUT	AUDIO OUT	IR	D. MIX	FRONT	SURR 1	CENTER	SURR 2
			COMPONENT

Connecting Components with

With (Remote Interactive) you can control the RDV-1.1 by using the remote controller supplied with

your Integra RESEARCH -compatible AV receiver.

Integra RESEARCH AV receiver

Y	Y	DIGITAL 1		DIGITAL 2		L		L
					IN
OUT
PB	PB				OUT	R		R
						REMOTE		SUB
		COAXIAL	OPTICAL	COAXIAL	OPTICAL	CONTROL	AUDIO OUT	WOOFER
PR	PR	DIGITAL 2
		( BALANCED)					HD VIDEO OUT
IN		AES/EBU					COMPONENT
						Y	PB	PR
S400
( AUDIO)						1
S VIDEO

			12V
			TRIGGER
	VIDEO		2
	S VIDEO	VIDEO
1	1+ 2		IN

SURR MODE

(AUDIO OUT)

HDMI

IN

HDMI

OUT

AV receiver, etc.

Signal flow

Notes:

• The RDV-1.1 supports HDCP (High-bandwidth Digi-

tal Content Protection), a protection system for digital

video. HDMI components that you connect to the

RDV-1.1 must also support HDCP.

DIGITAL IN

OPTICAL

REMOTE

CONTROL

cable (supplied)

REMOTE

OPTICALCONTROL

AUDIO IN

L

R

To use you must make an analog audio connection (RCA) between the RDV-1.1 and the other compo- nent even if they are already connected dig- itally.

D. MIX

L

R

AUDIO OUT

• The RDV-1.1 supports High-Definition Multimedia

Interface Specification Information Version 1.0.

RS 232	HDMI	VIDEO IN	VIDEO OUT	AUDIO OUT	IR	D. MIX	FRONT	SURR 1	CENTER	SURR 2
			COMPONENT

Y	Y	DIGITAL 1		DIGITAL 2		L		L
					IN
OUT
PB	PB				OUT	R		R
						REMOTE		SUB
		COAXIAL	OPTICAL	COAXIAL	OPTICAL	CONTROL	AUDIO OUT	WOOFER
PR	PR	DIGITAL 2
		( BALANCED)					HD VIDEO OUT
IN		AES/EBU					COMPONENT
						Y	PB	PR
S400
( AUDIO)						1
S VIDEO

			12V
			TRIGGER
	VIDEO		2
	S VIDEO	VIDEO
1	1+ 2		IN

SURR MODE

(AUDIO OUT)

Notes:

•Push the plugs in all the way to make a good connec- tion.

•Use only cables for connections.

• To use you must make an analog audio connec- tion (RCA) between the RDV-1.1 and Integra RESEARCH AV receiver, even if they are already connected digitally.

• The RDV-1.1 has two sockets. You can connect either one to the Integra RESEARCH AV receiver. The

other socket is for connecting additional -compat- ible components.

• Connect the RDV-1.1’s socket to only Integra RESEARCH components. Connecting to other manu- facturer’s components may cause them to malfunc- tion.

40