Integra RDV-1.1 instruction manual Controlling Other Components, Entering Remote Control Codes

Controlling Other Components

In addition to controlling the RDV-1.1, the remote con- troller can also be used to control your TV and VCR. To do this you need to enter the appropriate control codes for your TV and VCR. The remote controller can also learn individual commands from another remote control- ler (see page 92).

			Tx/Learn
On	Standby		indicator
Standby		TV
		I	Input
1	2	3	+
			TV CH
4	5	6	-

3

Remote controller

1 2 3

4 5 6

7 8 9

+10 0

Use the number buttons to enter the 4-digit remote control code. If the code is accepted, the Tx/ Learn indicator flashes slowly twice.

If the Tx/Learn indicator flashes quickly three times, the code has not been accepted, in which case you should try again from step 2.

Number	7		8	9
buttons
					TV VOL
	+10		0	Clear
Search		Memory Dimmer			Amp Input
	S		M	D	Input
			Amp Input
	DVD		V1	V2	V3	TV
			Mode
	DVD		Amp	VCR	TV
Zoom On					Picture Control	VCR
Audio			enu	M
		opM		enu
Sel		T
	+
	CH
	Zoom		Enter		VOL
	L Mode
	-
		R	eturn	p
				Setu
Display					Muting
Last Memory			Step/Slow		Random
Rec	LM				RD
	Audio	Subtitle		Angle	Resolution
	Audio	Subtitle		Angle	Rsltn
	Repeat		A-B		Aspect
	Repeat		A-B		Aspect
Video Input		Video Off		Learning
	V In		V Off	L1	L 2
Open/Close
				L 3	L 4
			RC-561DV

Notes:

•The learning mode will be cancelled if you don’t press any buttons for 30 seconds.

•In some cases, not all of the remote controller’s but- tons may work as expected.

•Individually learnt commands for the TV and VCR modes (see page 92) are deleted when a new remote control code is entered.

Entering Remote Control Codes

Entering the appropriate remote control code for your TV and VCR will allow you to control them with the RDV-1.1’s remote controller. You’ll need to perform this procedure twice to enter the codes for both your TV and VCR.

1	Look up the appropriate remote
	control code for your TV or VCR.
	See “Remote Control Codes” on
	page 88

2

Remote controller

Mode

VCR TV

While holding down the [VCR] or [TV] Mode button, press the [Standby] button, and then release both buttons.

The Tx/Learn indicator flashes slowly once, and then stays lit.

Standby

87