Integra RDV-1.1 Controlling Components That Are Out of Range, Controlling Other Out-of-range

Connecting—Continued

Controlling Components That Are Out of Range

You can use the following multiroom kits to control the RDV-1.1 when it’s out of range of the remote controller:

•Multiroom kits such as those made by Niles and Xan- tech.

Components

For another component that is out of range of its remote controller, you can use a commercially available IR emitter to retransmit the remote controller signals received at the RDV-1.1’s IR IN, as shown below.

RS 232	HDMI	VIDEO IN	VIDEO OUT	AUDIO OUT	IR	D. MIX	FRONT	SURR 1	CENTER	SURR 2
			COMPONENT

Y	Y	DIGITAL 1		DIGITAL 2		L	L
					IN
OUT
PB	PB				OUT	R	R
						REMOTE	SUB
		COAXIAL	OPTICAL	COAXIAL	OPTICAL	CONTROL	WOOFER

Connecting block

IR receiver

PR	PR	DIGITAL 2		AUDIO OUT
		( BALANCED)		HD VIDEO OUT
IN		AES/EBU		COMPONENT
			Y	PB	PR
S400
( AUDIO)			1
S VIDEO

			12V
			TRIGGER
	VIDEO		2
	S VIDEO	VIDEO
1	1+ 2		IN

SURR MODE

(AUDIO OUT)

IR

IN

OUT

Controlling the RDV-1.1 When It’s Out of Range

If the RDV-1.1 is located in another room, installed in a cabinet, or is out of range of its remote controller, you can use a commercially available IR receiver to pick up the remote controller signals and feed them to the RDV-1.1, as shown below.

IR receiver Connecting

block

IR IN

RDV-1.1

Remote controller

Inside cabinet

Signal flow

Connect the IR receiver to the RDV-1.1 as shown below.

from connecting block

Miniplug cable

Signal flow

IR

IN

OUT

RDV-1.1

IR IN
IR OUT	RDV-1.1

IR emitter

Remote controller

Other component

Signal flow

Connect the IR emitter to the RDV-1.1’s IR OUT, and place the IR emitter in front of the other AV component’s remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR emitter.

Other component

	Remote control
from connecting block	sensor
	IR emitter
Miniplug cable

IR

Miniplug

IN

OUT

RDV-1.1 IR Emitter

Signal flow

Only remote controller signals received by the RDV-1.1’s IR IN are fed through to the IR OUT. Signals picked up by the RDV-1.1’s remote control sensor are not.

Controlling Other Out-of-range

41