Integra RDV-1.1 instruction manual Troubleshooting, Audio Out settings?

Troubleshooting—Continued

Symptom	Possible cause	Remedy
SACD audio is not output	This is because the i.LINK Output Setting is
by the analog audio out-		Set the i.LINK Output Setting to Off (page 77).
	set to On.
puts?
	While the i.LINK Output Setting is set to On,
Can’t access the Analog	the Analog Audio Out Speaker Setting,	Set the i.LINK Output Setting to Off (page 77).
Audio Out settings?	Speaker Distance, and Test Tone settings have
	no effect and are unavailable.
Can’t play MP3 and JPEG	The disc is not ISO 9660 Level 2 format.	Use only ISO 9660 Level 2 format discs (page 11).
discs?	The disc has not been finalized.	Finalize the disc (page 11).
	MP3 files without a “.mp3” or “.MP3” file-	Use the correct filename extension (page 11).
	name extension are not recognized.
Can’t select MP3 files?
	The MP3 disc is a multisession disc.	Only files in the first session of a multisession disc
		can be played (page 11).
	JPEG files without a “.jpg” or “.JPG” or
	“.JPEG” filename extension are not recog-	Use the correct filename extension (page 11).
	nized.
	Only Baseline JPEG files are supported. Pro-	Use Baseline JPEG files (page 11).
Can’t view JPEG files?	gressive JPEG files are not.
	Only JPEG files with the following brightness/
	color difference ratios are supported: 4:4:4,	Use JPEG files with the supported ratio (page 11).
	4:2:2, and 4:1:1.
	The JPEG file is too big.	Use JPEG files that are less than 5 MB (page 11).
The message “NO PLAY”	The disc is dirty.	Remove the disc and clean it (page 12).
appears on the display?
	Power supply voltage fluctuations and other	Turn off the RDV-1.1, wait five seconds, then turn
Buttons on the remote con-		it on again. If that doesn’t resolve the issue, discon-
	anomalies, such as static electricity, can inter-
troller don’t work?		nect the power cord from the wall outlet, wait five
	fere with normal operation.
		seconds, reconnect it, then try again.
	There are no batteries in the remote controller.	Install new batteries (page 15).
	The batteries are flat.	Replace with new batteries (page 15).
	The batteries are installed incorrectly.	Check the batteries and correct as necessary
		(page 15).
	You’re not pointing the remote controller at the	Point the remote controller at the RDV-1.1’s
	RDV-1.1’s remote sensor.	remote sensor (page 15).
Buttons on the RDV-1.1
		Use the remote controller closer to the RDV-1.1
work OK but those on the
	You’re too far away from the RDV-1.1.	(page 15). The remote controller has a range of
remote controller don’t?
		approximately 16 ft. (5 meters).
	A strong light source is interfering with the	Make sure that the RDV-1.1 is not subjected to
		direct sunshine or inverter-type fluorescent lights.
	RDV-1.1’s remote sensor.
		Relocate if necessary.
	If the RDV-1.1 is installed in a cabinet with	Open the doors, or use a cabinet without colored
	colored glass doors, the remote controller may
		glass.
	not work reliably when the doors are closed.

95