Bacharach INSIGHT manual Setting UP the Analyzer, Preliminary Steps, Power

	Fyrite® INSIGHT
General Characteristics:
Power Requirements	Four disposable ‘AA’ Alkaline batteries (op-
	tional AC adapter is available)
Operating Time	Minimum of 20 hours continuous operation
	(pump running and backlight ON)
Warm Up Time	60 seconds
Memory	Up to 100 complete sets of
	combustion, temperature, & pressure
	tests can be saved in memory.
Display	128 x 64, LCD Graphic Display
Front Panel Controls	Eleven front panel push buttons
	(Refer to Section 3.4)
Interfaces	IrDA printer & USB connectivity
Accuracy:
Oxygen	±0.3% O2 with a typical flue gas
	concentration of CO2
Carbon Monoxide	±5% of reading or ±10 ppm, whichever is
	greater*, in the range of 0 to 1000 ppm.
Flue Gas Temperature	±4 °F between 32 & 255 °F
	(±2 °C between 0 & 124 °C)
	±6 °F between 256 & 480 °F
	(±3 °C between 125 & 249 °C)
	±8 °F between 481 & 752 °F
	(±4 °C between 250 & 400 °C)
Ambient/Primary	±2 °F between 32 & 212 °F
Temperature	(±1 °C between 0 & 100 °C
Draft	±2% of reading or ±0.02 InWC, whichever is
	greater in the range of -10 to +10 InWC

±3% in the range of -10 to -40 InWC

±3% in the range of 10 to 40 InWC

*Tighter CO accuracy in the lower ranges, up to ±2 ppm, may be attained if a lower range calibration gas (e.g. 100 ppm CO) is used.

Fyrite® INSIGHT

3.0SETTING UP THE ANALYZER

3.1Preliminary Steps

Before using the analyzer . . .

•Check batteries (Section 3.2)

•Connect probe to analyzer (Section 3.3)

•Check setup (Section 3.5)

3.2 Power

3.2.1 Installing or Replacing Batteries

Install fresh batteries as described below. Check the analyzer for sufficient charge prior to each use. Replace the batteries if the low-battery symbol appears in the upper right corner of the screen. To replace the batteries:

1.Remove battery cover from back of analyzer.

2.If old batteries are installed, remove them and properly discard.

3.Observing the polarity markings inside the battery compartment, install four ‘AA’ Alkaline batteries.

4.Replace battery cover.

3.2.2 Using the AC Power Adapter

The optional AC power adapter is capable of powering the analyzer on a continuous basis. The adapter plugs into an appropriate 100-240 VAC wall outlet and produces an output of +5 VDC. The adapter's output connector plugs into the analyzer's POWER jack located on the bottom of the unit. The batteries do not need to be removed when using the AC adapter.

3.3Connecting the Probe Hose & Thermo- couple

A rigid stainless steel probe with handle is connected to a flexible hose with integral water-trap / filter used to draw a gas sample into the ana- lyzer from the room, grilles, diffusers, and furnace flues.

6 Instruction 24-9460 Instruction 24-9460 7