Heat Controller BHD-501-G, BHD-651-G, BHD-301-G Operation with Continuous Drainage, Maintenance

Page 6

BHD-G Service Manual

Portable Dehumidifier with R-410A

Heat Controller, Inc.

 

 

 

3.4OPERATION WITH CONTINUOUS DRAINAGE

On the rear of the unit, remove the rubber plug carefully.

Remove the water tank first, then push the hose onto the connector located inside of the hole. The hose should go down smoothly without bends or kinks.

Place the end of the hose into a suitable drainage location for condensate removal.

3.5MAINTENANCE

3.5.1Precaution

Be sure to unplug the unit before cleaning.

Do not use harsh detergents, thinners or other chemical agents to clean the unit as this may damage the unit. Do not wash the unit directly under a tap or hose. The electrical components inside may be damaged and the unit become unsafe as a result.

3.5.2 Air filter

Clean the air filter at least once every two weeks to prevent impaired performance of the unit.

Pull the air filter out and Wash the air filter with clean water, and then carefully dry (see figure below).

3.5.3 Unit enclosure

Use a soft, clean cloth to wipe the surface. Do not use water as this may cause an electrical fault or shock hazard.

3.5.4 Water tank

Wash the tank using warm water 104°F (about 40°C) with neutral detergent. Rinse and allow to air dry. Replace tank when dry.

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Portable Dehumidifer Series With R-410A Table of Contents Insulation Resistance Test Safety PrecautionsUnit Features Control LocationsTimer Outside DimensionsTimer Set Control Operating Conditions Turning the Unit on or OFFOperation with Water Tank Maintenance Operation with Continuous DrainageContinuous Dehumidification Mode Powering on the UnitSetting the Relative Humidity Powering OFF the UnitGround Test Defective CompressorCompressor Winding Test Checking Compressor EfficiencyChecking the Internal Overload Hermetic Component ReplacementSealed Refrigeration System Repairs Equipment RequiredFAN Motor CapacitorCapacitor Test Trouble Shooting Troubleshooting GuideIdentify ALL Possible PCB Fault Codes Room Airconditioner Voltage LimitsHumidity sensor check Fail to start or fail to start motor Abnormal noise Complaint Cause RemedyPortable Dehumidifier with R-410A Complaint Cause Remedy Wiring Diagram 05/2010

BHD-301-G, BHD-651-G, BHD-501-G specifications

The Heat Controller BHD series, comprising models BHD-651-G, BHD-301-G, and BHD-501-G, is designed to meet diverse heating needs with efficiency and reliability. Each model incorporates advanced features and technologies that enhance user experience, making them ideal for both home and commercial use.

Starting with the BHD-651-G, this model is a powerhouse, offering significantly higher output capacity suitable for larger spaces. It boasts an intelligent thermostat that ensures precise temperature control, allowing users to maintain their preferred environment effortlessly. The BHD-651-G employs a dual heating technology, combining convection and radiant heat for balanced warmth. Additionally, its energy-saving mode optimizes power consumption without sacrificing comfort, making it an eco-friendly choice.

The BHD-301-G is designed for medium-sized areas, striking a perfect balance between power and portability. Featuring a sleek design, it is lightweight and easy to move around. One of its standout features is the programmable timer, allowing users to set heating schedules that align with their lifestyles. This model also includes a filter system that cleans and purifies the air while heating, ensuring a healthier indoor environment. Moreover, the BHD-301-G operates quietly, making it ideal for use in bedrooms or offices.

Finally, the BHD-501-G caters to a variety of settings where flexibility is crucial. This model is equipped with multi-directional airflow, enabling users to direct heat where it is most needed. The BHD-501-G also features an advanced safety system, including overheat protection and a tip-over switch, ensuring peace of mind during use. Its user-friendly interface with intuitive controls simplifies operation, allowing for effortless adjustments to temperature and settings.

In summary, the Heat Controller BHD series offers a comprehensive range of features designed to provide efficient heating solutions tailored to different environments. With technologies aimed at enhancing power efficiency, air quality, and user comfort, the BHD-651-G, BHD-301-G, and BHD-501-G models stand out as top choices for reliable heat management. Their innovative characteristics ensure that users can enjoy warmth and comfort in any setting while being mindful of energy consumption and safety.
Top Page Image Contents