WIRING THE DEHUMIDIFIER TO THE HVAC SYSTEM AND ZONE DAMPERS
NOTE: Use
Pull off the wiring access cover near the dehumidifier control to access the wiring terminals.. Snap the wiring access cover back into place after completing all wiring..
WIRING TO THE HVAC SYSTEM
When the dehumidifier is ducted to the HVAC system, it is recommended that it also be wired to the HVAC system as shown in Figure 22.. If ducted to the HVAC system in return to return configuration, the dehumidifier must be wired to the HVAC system to prevent short circuiting dehumidified air directly back to the dehumidifier inlet.. In return to supply ducting configuration, running the HVAC fan with the dehumidifier ensures the warm dry air is mixed with room air before being discharged to the home..
Optional W & Y Wiring
Wire the W and/or Y terminal to the HVAC system when using the ventilation feature of the dehumidifier (see VENTILATION on page 19)..
Wire the dehumidifier Y terminal to the HVAC system if it is desired to disable the dehumidifier compressor from operating when the air conditioning is running.. See DEH w/AC in SYSTEM
WIRING TO ZONE DAMPERS
FIGURE 23 – Two Zone Wiring On-Board Control
FIGURE 22 – Wiring to HVAC System
+- A B ODT VENT DEH Remote Sensor Dampers
DHDH |
| Gh Rf Cf HVAC |
FLOAT Switch | Gs W EQUIP. | |
|
| Y |
| EXISTING WIRE |
| OPTIONAL | |||||
| NEW WIRE |
|
|
|
| |||
|
|
|
|
| WIRES | |||
|
|
| HVAC |
|
| |||
|
| EQUIPMENT |
|
| ||||
THERMOSTAT |
|
|
|
|
|
| ||
| G |
|
|
|
| |||
|
|
|
|
|
|
| ||
| R | R |
|
|
| |||
|
|
|
| |||||
CC
G
WW
YY
+- A B ODT VENT DEH Remote Sensor Dampers
Switch
FLOAT DH DH
Gh Rf Cf Gs W Y HVAC EQUIP.
(40 VA min)
24 VAC
(PRIMARY ZONE) | (SECONDARY ZONE) |
NORMALLY CLOSED | NORMALLY OPEN |
14