7Installation Preparation
Prepare the existing solid fuel masonry or factory built
A. Inspection and Cleaning
Prior to installing the gas insert:
•Have the chimney and adjacent structure inspected and cleaned by qualifi ed professionals. Hearth & Home Technologies recommends that NFI or CSIA certified professionals, or technicians under the direction of certi- fi ed professionals, conduct a minimum of a NFPA 211 Level 2 inspection of the chimney.
•Replace component parts of the chimney and fi replace as specifi ed by the professionals.
•Ensure all joints are properly engaged and the chimney is properly secured.
•Ensure combustible mantel and surround clearances comply with applicable codes and regulations for solid- fuel fireplaces. In the absence of local or regional codes, refer to NFPA 211.
•Ensure chimney is constructed of
•Ensure chimney is clean and in good working order.
•Ensure that all chimney cleanouts fi t properly to prevent air leakage into chimney.
B. Flue Damper
Fully lock the solid fuel fi replace’s fl ue damper in the open position, OR completely remove it.
C. Gas Line
Note: If the factory built fireplace has no gas access hole provided, an access hole of 1 inch (25 mm) diameter or less may be drilled through the lower sides or bottom of the firebox in a proper workmanship - like manner. This access hole must be plugged with
•Install gas line into fi rebox cavity.
•Check local codes and gas line sizing requirements following NFPA51. See Section 9.
•It is recommended that extra length of gas line be installed within the existing wood burner or masonry fireplace to allow removal of the insert for future servicing needs.
D. Fireplace Conversion Notice
Permanently attach the label with the following warning to the inside lower back of the fi replace fi rebox into which the insert is being installed. Silicone or mechanical fasteners may be required to properly secure the label.
WARNING! Risk of Fire! This fireplace has been con- verted for use with a gas fireplace insert only and cannot be used for burning wood or solid fuels unless all original parts have been replaced, and the fireplace
E. Electrical Outlet Box
An outlet box may be installed in a bottom back corner of the existing solid fuel masonry or factory built fi replace to power the appliance. Each unit ships standard with a cord assembly to permit blowers or other optional acces- sories to be used. The accessories plug into the new out- let box or may be routed out onto the hearth to a nearby outlet.
20 | Heatilator • NDI30, |