Carrier manual 48SS036-060, Tran

Typical control wiring schematic,

48SS036-060; 460-3-60

		LEGEND
AWG	Ð American Wire Gage		PWR	Ð Power
BR	Ð Blower Relay		QT	Ð Quadruple Terminal
C	Ð Contactor		RS	Ð Rollout Switch
CAP	Ð	Capacitor	TRAN	Ð Transformer
CH	Ð Crankcase Heater			Field Splice
COMP	Ð Compressor Motor
CR	Ð Combustion Relay			Terminal (Marked)
EQUIP	Ð	Equipment
FS	Ð	Flame Sensor		Terminal (Unmarked)
FU	Ð	Fuse
GND	Ð Ground			Splice
GVR	Ð Gas Valve Relay			Splice (Marked)
HS	Ð Hall Effect Sensor
HV TRAN	Ð	High-Voltage Transformer		Factory Wiring
I	Ð	Ignitor
IDM	Ð	Induced-Draft Motor		Field Control Wiring
IFM	Ð	Indoor-Fan Motor		Field Power Wiring
IGC	Ð	Integrated Gas Control
LS	Ð	Limit Switch		Accessory or Optional Wiring
MGV	Ð Main Gas Valve			To Indicate Common Potential
NEC	Ð	National Electrical Code
				Only, Not to Represent Wiring
OFM	Ð Outdoor-Fan Motor

NOTES:

1.If any of the original wire furnished must be replaced, it must be replaced with type 90 C wire or its equivalent.

2.Use copper conductors only.

23