American Power Conversion manual APC NetworkAIR AFX Series Guide Specifications

Page 42

Monitoring system. The PC-based Supervisor System shall be shipped loose for single-terminal monitoring and control of up to 120 units. The program shall be run through Windows® and shall have status screens for individual unit conditions, mode of operation and alarms. The System shall graphically present temperature and relative humidity over time. Temperature, relative humidity, alarm history, etc. shall be recorded for future reference.

Environmental monitoring unit. An “EMU” shall ship loose complete with one 12' (305 mm) probe and network connection.

Hot water reheat. The unit shall be supplied with factory installed copper tube, aluminum fin, hot water reheat coil in place of electrical heater elements. Capacity shall be ______ MBH (kW) with ______ GPM (L/s) of

_______ ° F (° C) entering hot water temperature. Hot water shall be

controlled with an on/off solenoid valve.

Steam reheat. The unit shall be supplied with a factory-installed copper tube, aluminum-fin-reheat steam-coil in place of electrical heater elements. Capacity shall be _______MBH (kW) with 5 psi (35 kPa) of saturated steam.

Steam shall be controlled with an on/off solenoid valve.

Hot gas reheat. The unit shall be supplied with a factory-installed copper tube and aluminum fin hot gas reheat coil, in place of electrical heater elements. Air-cooled systems using hot gas reheat shall also include flooded condenser pressure controls. This is not available with remote-condensing units.

Premium efficiency motor(s). Each motor shall have a premium efficiency of no less than _______% per NEMA MG1-12.55.

High efficiency filter(s). Filters shall be_______% efficient per ASHRAE

Standard 52.1-92, UL Class2. The full 4" (102 mm) deep, pleated filters shall be replaceable from the top on downflow units and from the front on upflow units.

Prefilter(s). Replaceable 1" (25 mm) thick 25–30% efficient filter(s) shall be installed upstream of the final filters to lengthen service life.

Condensate pump, factory installed . A factory installed and wired condensate pump shall pump 36 gal/h (0.06 L/s) at 15' (4.6 m) head.

Condensate pump, ship loose. A condensate pump shall ship loose for field installation and wiring. Wiring shall be 120 VAC plug-in type. A check valve is also shipped loose. It shall have a capacity of 60 gal/h (0.06 L/s) at 15 ft (4.6 m) head.

350 PSI water regulating valves. The condensing temperature shall be automatically controlled by 2-way (3-way) 350 psi (2400 kPa) water regulating valve(s).

Flared connections for filter-drier.Flared connections shall be factory- installed on either side of the filter-drier to allow easy replacement.

Hot gas bypass. The unit shall be supplied with a factory installed hot gas bypass system to maintain efficient compressor operation during periods of low load. The valve shall automatically control the amount of hot gas bypassed to maintain the proper system capacity.

APC NetworkAIR AFX Series: Guide Specifications

37

Page 41 Page 43
Image 42
Page 41 Page 43
Contents NetworkAIRTM AFX Series Contents Guide Specifications Pump Specifications Page Upflow front-return Available ModelsDownflow Indoor top-discharge centrifugal condenserPage Capacity OverviewIntroduction Air patternHumidity control ConfigurationFront access ComplianceDwhu Model SelectionPage Standard Features MicroprocessorController Overall cabinet SetpointHumidifier Blower assemblyElectrical panel Electric reheatCondenser Clogged filter alarmCooling coil Air filterEmergency drain PanPage Environmental Optional FeaturesEmergency ExternalAPC NetworkAIR AFX Series Optional Features Reheat System ComponentsPage Performance Specifications Net cooling capacity-air/remote condensingModel Capacity in BTU/H Net cooling capacity-water 26T 28TNet cooling capacity-glycol Page Coolant requirements Performance DataAir system Pump systemFilters Water regulating valve-2-Way/3-Way, single seatedHumidification-solid state electrode canister Compressor-scrollHot water reheat Electric ReheatHot gas reheat Steam reheatConnection sizes Humidifier Electrical DataElectric Reheat-6-14 ton VoltageElectric Reheat-18-28 ton Steam/hot water/or no-reheat-6-14 ton Steam/hot water/or no-reheat-18-28 ton Indoor centrifugal condenser units Page Guide Specifications GeneralProduct APC NetworkAIR AFX Series Guide Specifications APC NetworkAIR AFX Series Guide Specifications APC NetworkAIR AFX Series Guide Specifications GPML/s at ft m external head, and operate on Ph, 60-Hz power Visual and audible alarm OptionsAPC NetworkAIR AFX Series Guide Specifications Page Dimensional Data Downflow-6-8 tonDownflow-10-18 ton Downflow-20-28 ton Upflow front-return-6-8 ton Upflow front-return-10-18 ton Upflow front-return-20-28 ton Upflow rear-return-6-8 ton Upflow rear-return-10-18 ton Upflow rear-return-20-28 ton Indoor rear-discharge centrifugal condenser-6-8 ton Indoor rear-discharge centrifugal condenser-10-18 ton Indoor rear-discharge centrifugal condenser-20-28 ton Indoor top-discharge centrifugal condenser-6-8 ton Indoor top-discharge centrifugal condenser-10-18 ton Indoor top-discharge centrifugal condenser-20-28 ton Page Air-Cooled Condensers and Drycoolers Key to the model numberAir-cooled condenser-physical data LbsAir-cooled condenser-electrical data Model TempFLA MCA MOP Single-fan air-cooled condenser-6 ton Dual-fan air-cooled condenser-6-14 ton Triple-fan air-cooled condenser-14-20 ton Dual-fan air-cooled condenser-20-26 ton Triple-fan air-cooled condenser-26-28 ton Glycol cooled drycooler-electrical data DrycoolerGlycol cooled drycooler-physical data Tonnage Ambient FLA MCA MOPDual-fan fluid cooler-6-8 ton Triple-fan fluid cooler-10-12 ton Dual-fan fluid cooler-14-18 ton Triple-fan fluid cooler-20-28 ton Page Pump Specifications Pump electrical dataFLA MCA Page Room preparation Guidelines for InstallationService access Unit locationFloorstand Power unitRigging Utility connectionsWater supply Page APC Worldwide Customer Support

AFX Series specifications

The American Power Conversion (APC) AFX Series is a groundbreaking line of uninterruptible power supplies (UPS) designed to meet the demands of modern businesses. APC, a subsidiary of Schneider Electric, is known for its reliable power management solutions that ensure the availability of critical equipment. The AFX Series stands out for its advanced features, cutting-edge technologies, and robust characteristics that cater to a diverse range of applications.

One of the standout features of the AFX Series is its flexible architecture. The series offers modular scalability, allowing users to expand power capacity as needed. This modular design is particularly beneficial for growing businesses that require a power solution that can adapt to changing demands without the need for a complete replacement. The AFX units boast a compact footprint, making them suitable for deployment in server rooms, data centers, or environments with space constraints.

Another significant characteristic of the AFX Series is its high efficiency. The UPS units are designed to operate at a remarkable efficiency level, often exceeding 95%, which translates into reduced energy consumption and lower operating costs. This efficiency not only benefits the environment but also enhances the overall reliability of power delivery.

In terms of technology, the AFX Series leverages advanced lithium-ion battery technology. Lithium-ion batteries have a longer lifespan and faster charge times compared to traditional lead-acid batteries. This innovation ensures that uptime is maximized, while maintenance efforts are minimized, allowing IT personnel to focus on more critical tasks.

The AFX Series is also equipped with intelligent monitoring and management features. Users can take advantage of real-time data and analytics through an intuitive web interface, providing insights into power performance and battery health. This capability aids in proactive maintenance, ensuring potential issues are addressed before they lead to downtime.

Furthermore, the AFX Series supports a range of connectivity options, including SNMP, USB, and serial interfaces. These options enable seamless integration into existing management systems, allowing for centralized monitoring and control.

In summary, the American Power Conversion AFX Series is a powerful solution for organizations seeking reliability, efficiency, and scalability in their UPS systems. With its modular architecture, high operational efficiency, advanced lithium-ion technology, and user-friendly management capabilities, the AFX Series is an exemplary choice for businesses aiming to safeguard their critical infrastructure against power interruptions.
Top Page Image Contents