Hearth and Home Technologies CFX-Crescent owner manual Trapezoid Termination Cap

For trapezoidal termination:

1.Screw the cap to the exterior wall through the flanges in the cap.

2.Seal the joint between the pipe and the exterior firestop.

HEAT

SHIELD

Note: You must install the heat	6-3/4”
shield while installing the top two	(171m m )

screws in the firestop.

Figure 17. Trapezoid Termination Cap

NOTE: For vinyl siding use protector kit VPK-Infinity.

WARNING: VENTING TERMINALS SHALL ! NOT BE RECESSED INTO A WALL OR SID- ING. VENT TERMINATION CLEARANCES MUST BE FOLLOWED TO AVOID FIRE DANGER.

SEE VENT TERMINATION MINIMUM CLEARANC- ES DIAGRAM ON FOLLOWING PAGE.

Heat & Glo • CFX-CRESCENT • 705-900 Rev. P • 12/07 23