Hearth and Home Technologies CFX-Crescent owner manual Optional Accessories, Wall Switch

	Optional Accessories
	Optional remote control kits require that 110-120
	VAC be wired to the fireplace junction box.
	Wall Switch
	A wall switch is provided and is required. Position
	the wall switch in the desired position on the wall.
	The wall switch is 110-120 VAC and requires
	appropriate wire be used. A junction box should be
	used for the wire connections. See wiring diagram
	for details.
	At the appliance connect the wire to the ON/OFF
	switch pigtails.
CAUTION	LABEL ALL WIRES PRIOR TO DISCONNEC-
	TION WHEN SERVICING CONTROLS. WIRING
	ERRORS CAN CAUSE IMPROPER AND DAN-
	GEROUS OPERATION. VERIFY PROPER OPER-
	ATION AFTER SERVICING.

	PLUG-IN
3V TRANSFORMER
							IGNITION	INTERMITTENT
LOW VOLTAGE		FLAME SPARKER/					MODULE 3 VAC	PILOT
								IGNITION
SEE NOTE 1		SENSOR
HIGH				FAN
TEMP	IGNITION
SWITCH
	MODULE
	(3V)
	VALVE	LOW VOLTAGE
		SEE NOTE 1
	GROUND							ORG
		REMOTE
NEUTRAL		CONTROL	HOT					WHT
								GROUND TO
			BLK			WHT		FIREPLACE
								CHASSIS
			RELAY
					BRN			BRN
					BRN		HIGH LIMIT
							SWITCH
REMOVE THESE CONNECTORS							BRN
TO WIRE SWITCHES								ORG	GRN
OPTIONAL				WHT
		YLW	YLW
WALL
SWITCH		BLK		WHT
			BLK
OPTIONAL		YLW
REMOTE					PLUG IN
CONTROL				XFMR
		BLK
REMOVE THESE CONNECTORS				FAN
	TO WIRE REMOTE	JUNCTION BOX				TRANSFORMER		VALVE
		120 VAC				3 VAC

Figure 24. Intermittent Pilot Ignition Wiring Diagram

30 Heat & Glo • CFX-CRESCENT • 705-900 Rev. P • 12/07