Hearth and Home Technologies Tucson (8700) Fire Hazard, Must be Vented to Outside, HOT Surfaces

Page 6

HearthStone Quality Home Heating Products Inc

Tucson Model #8700

the heater off and call a qualified service technician.

The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of ½ psig. (3.5k Pa). The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than ½ psig (3.5k Pa).

FIRE HAZARD

Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this appliance. The Tucson should be located out of traffic and away from furniture, draperies, clothing, and flammable material.

SHOCK HAZARD

(When equipped with an optional blower)

This appliance is equipped with a three-prong (grounding) plug for protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from the plug.

MUST BE VENTED TO THE

OUTSIDE

Never vent the gas heater to other rooms or buildings. This gas appliance must not be connected to a chimney flue serving a separate solid-fuel burning appliance.

SERVICE CAUTION

If you believe your Tucson is not, in any way, performing properly, immediately discontinue operation until the unit has been inspected and approved by qualified service personnel. Prior to servicing the unit, turn the valve control knob clockwise to “OFF”.

The unit should be cool prior to servicing and cleaning. Any safety screen, guard, or component removed during servicing should be replaced prior to operation. Use of any components not supplied by HearthStone on the stove voids all warranties. Do not substitute components.

HOT SURFACES

Certain exposed surfaces of the Tucson will reach high temperatures during normal operation. Clearances to combustibles must be maintained, as specified in the “Clearances To Combustibles” section of this manual. Due to high temperatures the appliance should be located out of traffic and away from

furniture, draperies, clothing and flammable materials. Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns to skin or clothing ignition. Young children should be carefully supervised when in the same room as the appliance. Clothing or other flammable material should not be placed on or near the appliance. (Surveille les enfants. Garder les vêtements, les meubles, l’essence ou autres liquides à vapeur inflammables lin de l’appareil.) Clean the area around, under, and behind the unit on a regular basis to prevent the accumulation of dust and lint.

NEVER BURN PAPER, WOOD OR OTHER MATERIALS

This gas heater is designed to burn natural gas or liquid propane (LP). Never burn any fuel not intended for use with this unit.

WARNING

This gas appliance must not be connected to a chimney flue serving a separate solid-fuel burning appliance

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents What to do if YOU Smell GAS QUE Faire SI Vous Sentez UNE Odeur DE GAZTucson Model #8700 Information Sheet What WhenIntroduction Safety Information Must be Vented to Outside Service CautionFire Hazard HOT SurfacesCeramic Fiber LOG Safety Information Electrical HazardDo not Light Pilot or Main Burners by Hand Mobile Home Installations Specifications OWNER’S Information Routine Maintenance and CareCleaning Daily OperationFIREBOX, PILOT, & Burner Tubes Pilot Flame PatternClass Cleaning Replace the Front Door Gasket AS NeededCodes INSTALLER’S InformationItems Required for Installation Packing ListUnpacking and Inspection Hearth REQUIREMENT/FLOOR ProtectionClearance to Combustibles Minimum Venting-Mantle Clearance ToSnorkel-Wall Clearance To Combustibles Acceptable Direct-Vent Termination Cap locations Venting Information Venting ConnectionAdjustment to Restriction Plate Restriction PlateRestriction Plate Position Approved Venting System Components Venting Components ConfigurationAcceptable DIRECT-VENT Termination CAP Locations Chimney Liner SystemComponents For a Typical Snorkel Installation Clearances from the pipe to combustibles Approved Venting Configuration for Horizontal Termination 90 0 ElbowApproved Configuration for Fireplace Installation Co-Linear & Chimney as Air InletVenting KIT KIT #97-65001 Thermostat Wiring Remote ControlThermostat Placement Electrical ConnectionsWiring Diagram Tucson Wiring InstructionsGAS Supply Connections GAS ConnectionsGAS Supply LOG Placement Installation of the LOG SETRemoval of LOG SET Log SetSmoke and Fumes Warning BREAK-IN ProcedureLighting the Unit for the First Time BREAK-IN WarningPrepare for Lighting Initial AdjustmentsPilot Light Warning Variable Output ControlLighting Instructions AIR Shutter Adjustments To Turn OFF GAS to AppliancePilot Adjustment Burner Flame AppearanceFirebox Maintenance CareCleaning › Warning do not Clean the Unit When IT’S HOT Pilot & Burner FlamesCleaning the Glass Parts Lists › WarningTroubleshooting Troubleshooting Troubleshooting Limited THREE-YEAR Warranty Limited Lifetime WarrantyLimited FIVE-YEAR Warranty Limited ONE-YEAR WarrantyQualifying for Warranty Coverage ExclusionsWarranty Registration Remedy

Tucson (8700) specifications

Hearth and Home Technologies Tucson (8700) represents a significant advancement in the realm of home heating solutions. This gas fireplace model combines elegant design with cutting-edge technology, providing both aesthetic appeal and functional efficiency. The Tucson is designed to serve as a focal point in any living space while delivering warmth and comfort.

One of the main features of the Tucson (8700) is its sleek, modern design. Available in a variety of finishes, the fireplace fits seamlessly into a range of decor styles, from contemporary to traditional. Its large viewing area provides an unobstructed view of the flames, creating an inviting ambiance. The glass front is both stylish and functional, enhancing the overall appeal while maximizing heat output without compromising safety.

The Tucson is engineered with advanced technology that prioritizes efficiency and convenience. It utilizes a direct vent system, ensuring that the fireplace draws air from the outside and expels exhaust gases efficiently, improving indoor air quality. This feature allows for installations in a variety of locations within the home without the need for traditional chimney systems.

Another notable characteristic is its adjustable flame height and heat output. Homeowners can easily customize the warmth and ambiance to suit their preferences, providing versatile heating options for various occasions. The Tucson includes a remote control feature, allowing users to operate the fireplace without having to leave their comfortable seating area.

Safety is a key consideration in the design of the Tucson (8700). Equipped with an automatic shutoff feature, the fireplace will turn off if it detects any irregularities, ensuring peace of mind for users. The glass front remains cool to the touch, minimizing the risk of burns.

Additionally, the Tucson can be complemented with a variety of decorative options, including log sets and decorative media, allowing homeowners to create a personalized look that matches their style. This flexibility, along with its efficiency and stunning design, makes the Hearth and Home Technologies Tucson (8700) a standout choice for modern homes seeking both beauty and warmth.
Top Page Image Contents