Hearth and Home Technologies Tucson (8700) owner manual Mobile Home Installations

Page 8

HearthStone Quality Home Heating Products Inc

Tucson Model #8700

MOBILE HOME INSTALLATIONS

This appliance may be installed in an

aftermarket, permanently located, manufactured (mobile) home, where not prohibited by local codes.

This appliance is only for use with the type(s) of gas indicated on the rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.

(Cet appareil peut être installé dans un maison préfabriquée (mobile) déjá installée

ádemeure si les réglements locaux le permettent.

Cet appareil doit être atilisé uniquement avec les types de gas indiqués sur la plaque signalétique. Ne pas l’utiliser avec d’autres gas sauf si un kited conversion certifié est installé. )

SERVICE CAUTION

Any shield, door, or safety screen component removed for servicing will be replaced prior to operating. If you believe your Tucson is not performing properly in any way what so ever, immediately discontinue operation until the unit has been inspected by qualified service personnel. Always shut off the gas and electricity to the stove while servicing. Make sure the unit is not hot when servicing or cleaning. Use of

any components not supplied by HearthStone on the stove or vent system voids all warranties. Do not substitute components.

8

Image 8 Contents
What to do if YOU Smell GAS QUE Faire SI Vous Sentez UNE Odeur DE GAZTucson Model #8700 Information Sheet What When Introduction Safety Information Service Caution Fire HazardMust be Vented to Outside HOT SurfacesDo not Light Pilot or Main Burners by Hand Ceramic Fiber LOG Safety InformationElectrical Hazard Mobile Home Installations Specifications Routine Maintenance and Care CleaningOWNER’S Information Daily OperationFIREBOX, PILOT, & Burner Tubes Pilot Flame PatternClass Cleaning Replace the Front Door Gasket AS NeededINSTALLER’S Information Items Required for InstallationCodes Packing ListUnpacking and Inspection Hearth REQUIREMENT/FLOOR ProtectionClearance to Combustibles Minimum Venting-Mantle Clearance ToSnorkel-Wall Clearance To Combustibles Acceptable Direct-Vent Termination Cap locations Venting Information Venting ConnectionRestriction Plate Position Adjustment to Restriction PlateRestriction Plate Venting Components Configuration Acceptable DIRECT-VENT Termination CAP LocationsApproved Venting System Components Chimney Liner SystemComponents For a Typical Snorkel Installation Clearances from the pipe to combustibles Approved Venting Configuration for Horizontal Termination 90 0 ElbowApproved Configuration for Fireplace Installation Co-Linear & Chimney as Air InletVenting KIT KIT #97-65001 Remote Control Thermostat PlacementThermostat Wiring Electrical ConnectionsWiring Diagram Tucson Wiring InstructionsGAS Supply GAS Supply ConnectionsGAS Connections LOG Placement Installation of the LOG SETRemoval of LOG SET Log SetBREAK-IN Procedure Lighting the Unit for the First TimeSmoke and Fumes Warning BREAK-IN WarningInitial Adjustments Pilot Light WarningPrepare for Lighting Variable Output ControlLighting Instructions AIR Shutter Adjustments To Turn OFF GAS to AppliancePilot Adjustment Burner Flame AppearanceMaintenance Care Cleaning › Warning do not Clean the Unit When IT’S HOTFirebox Pilot & Burner FlamesCleaning the Glass Parts Lists › WarningTroubleshooting Troubleshooting Troubleshooting Limited Lifetime Warranty Limited FIVE-YEAR WarrantyLimited THREE-YEAR Warranty Limited ONE-YEAR WarrantyQualifying for Warranty Coverage ExclusionsWarranty Registration Remedy