Hearth and Home Technologies SANTAFEI-B owner manual

R

Santa Fe Pellet Insert

F. Igniter Replacement G. Glass Replacement

Igniter Bracket

Thumb Screw Igniter

Figure 36.1

a.Shut down the appliance by turning down the thermostat and let the appliance completely cool down. After the appliance has cooled down, unplug it and remove the ash drawer.

b.The wire leads to the igniter are connected to the wire harness with 1/4 inch (6mm) male / female spade connectors. These wires will pull forward approximately 4 to 5 inches (102mm to 127mm) through the grommet at the back of the ash drawer chamber. Disconnect the spade connections and remove the igniter from the chamber. Loose the thumb screw and slide igniter out.

c.Install new igniter into the chamber and tighten the thumb screw. Re-connect the wires to the 2 leads with the spade connectors.

d.Push excess wire leads back through the grommet, one wire at a time, to take-up the 4 to 5 inches (102mm to 107mm) previously pulled out. This will keep the wires out of the way of the ash drawer. Double check that the igniter wires are clear of any movement, i.e. ash drawer, firepot cleaning rod, cleaning slide plates, etc.

f.Re-install the ash drawer and then re-install the side panel and re-connect the power.

WARNING

•Glass is 5mm thick high temperature heat- resistant ceramic glass.

•DO NOT REPLACE with any other material.

•Alternate material may shatter and cause injury

a.The door handle and face must be removed first. Follow instructions found on page 19.

b.Remove door from the insert and lay on a flat surface face down.

c.Using a screwdriver, tap the bottom of the rope retainer rod to push it up out of the hole. The top end of the rod will slide up. Swing the rod toward you from the bottom and remove the rod. Repeat for other side.

d.Remove old glass and replace with new glass.

e.Slide the retainer rod into the top hole first, and then line up the bottom crimped end with the hole in the door. The crimped end must be parallel with the glass in order to insert it into place. Figure 36.2.

Rope Retainer

Rods

Slide this

end in first

Glass

Crimped end

at the bottom

Crimped end must be

parallel with the glass

Figure 36.2

Page 36 7019-205C September 1, 2008