LG Electronics 1003C operation manual Floor Protection, USA Requirements, Canada Requirements

Page 5

PLANNING YOUR INSTALLATION

FLOOR PROTECTION

This appliance requires non-combustible floor protec- tion for ember protection. If the floor protection is to be stone, tile, brick, etc., it must be mortared or grouted to form a continuous non-combustible surface. If a chim- ney connector extends horizontally over the floor, pro- tection must cover the floor under the connector and at least 2" (51 mm) to either side.

The floor protection must extend completely beneath the stove and to the front, sides, and rear as indicated:

USA REQUIREMENTS

16” (406 mm) min. to the front of the fuel door glass

8” (203 mm) min. beyond the sides of the fuel door opening

0” (0 mm) min. to the back of the stove body

CANADA REQUIREMENTS

18” (457 mm) min. to the front of the fuel door glass 8” (203 mm) min. beyond the sides of the stove body 8” (203 mm) min. to the back of the stove body

PAGE 5

STANDARD PARALLEL HEARTH PAD SHOWN

				0” - USA
				8” – Can.
STOVE TOP
8” (203 mm)				8” (203 mm)
Canada				Canada
	DOOR

8” (203 mm)				8” (203 mm)
USA			– Can-	USA
18” (457 mm)			– Can-
	ada
16” (406 mm)			USA

Image 5

Contents 775003M, Rev. P, 11/03 EPA Certified Catalytic Wood Burning StoveImportant Warnings Table of Contents Selecting a Location Planning Your InstallationSmoke Detectors USA Requirements Floor ProtectionCanada Requirements Standard Parallel Hearth PAD ShownCombustible Wall Clearances Protected Wall Clearance Alcove ClearancesReduced Masonry Structure Clearance Alcove AIR Intake Cover InstallationOutside AIR Stove Outside Air Floor Duct Floor ProtectorSecuring the Stove to the Floor Acceptable Connector Pipe for INSTALLA- TionsGrounding Stove Remove ASH Drawer ClipVapor Barrier At Chimney Penetration Chimney InspectionChimney Height Requirements 2’ by 10’ Rule for Vent TerminationDraft Requirements Draft Test ProcedureResidential Standard Using 6 152 mm Diameter Type L-Vent Connector PipeManufactured Mobile Home Standard Important NotesMethod B 228.6 mm Clearance to Combustible Wall Member Sides, to maintain the 9 228.6 mm air space. When fasteningWall pass-through with a minimum 9 228.6 mm air space be Inside wall of the Solid-Pak chimney. The inner endCare and OPERATI0N Glass Care and OperationFuel Door BREAK-IN Period HOW to Start and Maintain a FireRefueling Catalytic Temperature ProbeBypass Damper Control Burn Recommended FuelFuel MaintenanceReplacing Glass Door / Glass Gasket and ASH Drawer GAS- KETSide Cut-Away View of Firebox Catalyst ReplacementTroubleshooting Catalyst Deactivation Catalyst PluggingCatalyst Substrate Cracking Catalyst SubstrateOverfiring Caused From Improper Operation Overfiring Caused From Improper InstallationOverfiring Damage Fire Box Size Cubic feet Specifications Model 1003CItem no Description Replacement Parts List Model 1003C Catalytic Combustor System Components Damper AssemblyStove-Stat Kit SSK Outside Air Floor Duct OAFD-SBlower Kit BK-100 Variable Speed Control, Dial-A-TempSAFETY/LISTING Label EPA Label Ownership Records Service and Maintenance LOGWest Taft Avenue Orange, CA