Operation
Remote
Control Operations
The controls will look like the following.
Controls
Signal transmitter
5 |
|
| 1 |
6 |
|
|
|
|
|
| 3 |
4 |
|
|
|
2 |
|
| 10 |
| CANCEL |
| |
|
| 9 | |
7 | OFF | SET | |
ON | 12 | ||
11 |
| AUTO CLEAN | |
8 |
|
| 17 |
| ° C/° F | 18 | |
13 |
| ||
|
| ||
|
| 14 | |
15 |
|
| |
|
| 16 |
1. START/STOP BUTTON
Operation starts when this button is pressed and stops when the button is pressed again.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3.ROOM TEMPERATURE SETTING BUTTONS Used to select the room temperature.
4.INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps low, medium, high and CHAOS.
5. JET COOL/HEATING(OPTIONAL)
Used to start or stop the speed cooling/heaing.
(speed cooling/heating operates super high fan speed in cooling/heatig mode.)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and set the desired up/down airflow direction.
7.ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
8.TIME SETTING BUTTONS Used to adjust the time.
9.TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained and to cancel the Timer operation.
10.SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
11.AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
12.ROOM TEMPERATURE CHECKING BUTTON Used to check the room temperature.
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover 
Healthy Dehumidification Operation
Heating Operation
• Cooling Model(
), Heat Pump Model( 
)
13.NEO PLASMA(OPTIONAL)
Used to start or stop the
14.HORIZONTAL AIRFLOW DIRECTION CONTROL BUTTON (OPTIONAL)
Used to set the desired vertical airflow direction.
15.RESET BUTTON
Used prior to resetting time.
16.2nd F Button
Used prior to using modes printed in blue at the bottom of buttons.
17.AUTO CLEAN (OPTIONAL) Used to set Auto Clean mode.
18.°C/°F SWITCH BUTTON
Used to switch temperature reading from Centigrade to Fahrenheit.
44Room Air Conditioner