LG Electronics 230/208V service manual Control BOX Half-Disassembly, Control BOX Full-Disassembly

2.1.2 CONTROL BOX (Half-Disassembly)

1.Remove the front grille. (Refer to section 2.1.1)

2.Remove the three screw which fasten the control

	box. (See Fig. 2)
3.	Pull the control box from the barrier. (See Fig.2)
4.	Discharge the capacitor by placing a 20,000 ohm
	resistor across the capacitor terminals.
5.	Disconnect three wire housings in the control box.
6.	Pull the control box forward completely.
7.	Re-install the components by referring to the
	removal procedure. (See Fig. 2)
	(Refer to the circuit diagram found on page 25 in	Figure 2
	this manual and on the control box.)

2.1.3 CONTROL BOX (Full-Disassembly)

1. Remove the front grille. (Refer to section 2.1.1)

2. Remove the 4 screws which fasten the control box cover. (See Fig.3)

3. Disconnect three wire housings in the control box.

4. Remove three screws which fasten the control box assembly.

5. Pull the control box assembly out from the unit.

Figure 3

—10—