2.3.5 POWER CORD
1.Remove the control box. (Refer to section 2.1.2)
2.Disconnect the grounding screw from the control box.
3.Disconnect 2 receptacles.
4.Remove a screw which fastens the clip cord.
5.Separate the power cord from the control box. (See Fig. 12)
6.
(Use only one 
for ground connection.)
7.If the supply cord of this appliance is damaged, it must be replaced by the special cord.
(The special cord means the cord which has the | Figure 12 |
| |
same specification marked on the supply cord |
|
fitted to the unit.) |
|
2.3.6 P.C.B.
1.Remove the escutcheon.
2.Remove the two knobs.
3.Remove the 2 screws which fasten P.C.B. cover.
4.Disconnect all the leads which connected to the P.C.B.
5.Remove the two screws which fasten the P.C.B. board.
6.
Figure 13