LG Electronics 230/208V AIR Handling Parts, Heater Assembly and Cross Flow FAN, 2 FAN

2.2 AIR HANDLING PARTS

2.2.1 HEATER ASSEMBLY AND CROSS FLOW FAN

1. Remove the front grille. (Refer to section 2.1.1)

2. Remove the control box assembly. (Refer to section 2.1.3)

3. Remove the 3 screws which fasten the net steel. (See Fig. 4)

4. Remove the 3 screws which fasten the electric heater assembly. (Electric heater model only) (See Fig.4).

Figure 4

5. Loosen the hexagon screw with the Hex-wrench (See Fig.5)

Figure 5

6. Remove the 4 screws which fasten the indoor motor and the earth wire. (See Fig. 5. 6)

7. Re-install the components by referring to the removal procedure, above.

2.2.2 FAN

1. Remove the brace.

2. Remove the 4 screws which fasten the condenser Figure 6 with the shroud and the basepan.

3. Move the condenser sideways carefully.

4. Remove the clamp which secures the fan with pliers.

5. Remove the fan. (See Fig. 7)

6. Re-install the components by referring to the removal procedure, above.

Figure 7

—11—