State Industries 186589-001 Combustion AIR and Ventilation, Vent Terminal Clearances

Page 15

COMBUSTION AIR AND VENTILATION

When determining the installation location for a direct vent water heater, snow accumulation and drifting should be considered in areas where applicable.

VENT TERMINAL CLEARANCES

The vent system must terminate so that proper clearances are maintained as cited in local codes or the current edition of the National Fuel Gas Code ANSI Z223.1/NFPA 54 as follows:

FIGURE 11

Be sure venting is properly connected to prevent escape of dan- gerous flue gases which could cause deadly asphyxiation.

*Minimum 9 in. (23 cm) for appliances with 10,000 btuh (3 Kw) to 50,000 btuh

(15 Kw) inputs and 12 in. (30 cm) for appliances greater than 50,000 btuh (15 Kw) to

a window or door that may be opened

Minimum 18 in. (46 cm)

 

 

Minimum 3 ft. (91 cm) within a

12 in. (30 cm)

height of 15 ft. (4.6 cm) above

meter/regulator assembly

above grade or

anticipated snow

 

level

Minimum 3 ft. (91 cm) clearance

 

to service regulator vent outlet

12 in. (30 cm)

from soffit

Minimum

7 ft. (2.3 m)

above

public sidewalk

or paved driveway

(see footnote 2)

Minimum

12 in. (30 cm)

from sides, above or below a permanently closed window or door

VENT TERMINAL

*

AIR SUPPLY INLET

Minimum

 

Minimum 12 in. (30 cm)

2 ft. (61 cm)

 

under veranda, porch,

from outside

 

deck or balcony

corner

 

(see footnote 1)

*

*

Minimum

 

 

3 ft. (91 cm)

 

 

above if within

 

 

10 ft. (3 m)

*

 

horizontally to

 

a mechanical air

supply inlet

*

Minimum 9 in. (23 cm) for appliances with 10,000 btuh (3 Kw)

 

to 50,000 btuh (15 Kw) inputs and 12 in. (30 cm) for appliances greater

 

than 50,000 btuh (15 Kw) to a non mechanical air supply inlet

 

into building or combustion air inlet to another appliance

AREA WHERE TERMINAL IS NOT PERMITTED

1.Permitted only if veranda, porch, deck or balcony is fully opened on a minimum of two sides beneath the floor.

2.A vent shall not terminate above a sidewalk or paved driveway that is located between two single family dwellings and serves both dwellings.

FIGURE 12

15

Image 15
Contents Residential GAS Water Heaters Important Definitions Safe INSTALLATION, USE and ServiceGeneral Safety Introduction Table of ContentsKeep Clear of ALL Obstructions GET to Know Your Water Heater Replacement Parts Typical InstallationHotter Water can Scald Mixing Valve UsageFacts to Consider about the Location Locating the NEW Water HeaterInsulation Blankets Ventilation for Appliances Located in Confined SpacesVent Termination General Installing the NEW Water HeaterRequired Ability Inspect ShipmentValve and Pipe Insulation if Supplied TEMPERATURE-PRESSURE Relief ValveWater Potable Heating and Space Heating Closed Water SystemGAS Piping GAS Piping with Flexible Connector High Altitude Installations Sediment Traps Filling the Water HeaterVenting Vent Terminal Clearances Combustion AIR and VentilationHigh Rise Vent Arrangement DV Termination Safety CoverVent Connections Locating Clearance Hole for VentUncompressing the Corrugated Tubing Vent AssemblySecuring Vent Termination Assembly to the Exterior Wall Standard Vent ArrangementOffset Vent Arrangement Figure D TOP KnobTemperature Regulation Temperature RegulationOperational Conditions For Your InformationExternal Damage Start UP ConditionsAIR in HOT Water Faucets Maintenance Venting System InspectionPilot and Main Burner Cathodic Protection Anode Temperature & Pressure Relief ValveAnode ROD Maintenance DrainingDrain Valve Washer Replacement Leakage Checkpoints ServiceProblem Possible Causes Correction Troubleshooting GuidelinesThermostat Fails to Slow HOT Water RecovERY Drip from Relief ValvePage Conditions and Exceptions Series Tank PartsLimitation on Implied Warranties Service and Labor ResponsibilityClaim Procedure Installation InformationTennessee Waltz Parkway Ashland CITY, TN

186589-001 specifications

State Industries 186589-001 is a highly efficient water heater designed to meet both residential and commercial hot water demands. Known for its durability and exceptional performance, this unit is a popular choice among homeowners and business owners alike.

One of the standout features of the State Industries 186589-001 is its robust construction. The tank is made from high-quality materials that offer superior insulation, reducing heat loss and improving overall energy efficiency. This ensures a longer lifespan for the unit while minimizing operating costs. The model also features a glass-lined tank, which prevents corrosion and extends the longevity of the water heater.

The 186589-001 employs innovative heating technologies, including an advanced control system that provides precise temperature regulation. This allows users to set their desired water temperature easily, ensuring optimal comfort and safety. With a powerful heating element, the water heater can quickly heat water to desired levels, providing a reliable supply for various applications, from daily bathing to commercial needs.

Furthermore, the State Industries water heater is equipped with multiple safety features. An automatic shut-off function is integrated to protect against overheating, ensuring user safety during operation. Additionally, the model comes with a pressure relief valve, preventing potential hazards from excessive pressure build-up.

In terms of energy efficiency, the 186589-001 meets and often exceeds current industry standards. Its design minimizes energy consumption, which not only lowers utility bills for users but also aligns with environmentally sustainable practices.

The unit is designed for easy installation, making it convenient for both professionals and DIY enthusiasts. Clear instructions are provided, and the compact size allows it to fit in tight spaces, an advantage for those with limited installation options.

Overall, the State Industries 186589-001 stands as a reliable choice for those seeking a quality water heater with excellent features, advanced technology, and safety characteristics. Its commitment to durability and efficiency makes it a valuable investment for anyone in need of consistent hot water supply.