Husqvarna E10 manual Inserting the Needle

Page 15

INSERTING THE NEEDLE

Change the needle regularly, especially if it is showing signs of wear and causing problems.

Insert the needle following the illustrated instructions.

A.Loosen the needle clamp screw and tighten again after inserting the new needle. (1)

B.The ﬂat side of the needle shaft should be towards the back. C/D.Insert the needle as far up as it will go.

Attention:

Turn power switch to off (“O”).

Needles must be in perfect condition. (2)

Problems can occur with:

A.Bent needles

B.Damaged points

C.Blunt needles

15

Image 15

Contents E10 Important Safety Instructions Congratulations List of Contents Principal Parts of the Machine Page Accessories Fitting the SNAP-IN Accessory BOX For USA and Canada Connecting the Machine to Power SourceFoot control Sewing lightChanging the Bulb TWO-STEP Presser Foot Lever Adjust Presser Foot PressureRemoving the presser foot Attaching the Presser Foot SHANK/ AnkleAttaching the presser foot holder Attaching the presser footPlease Note Winding the BobbinInserting the Bobbin Inserting the Needle Threading the Upper Thread Thread Tension Bringing UP the Bobbin Thread Reverse Sewing Removing the FabricCutting the Thread NEEDLE, FABRIC, Thread Selection Guide Matching Needle / Fabric / ThreadStraight Stitching Straight stitching center needle positionStraight stitching right needle position Zigzag Stitching Function of stitch length dial while zigzagingStitch length dial HOW to SEW Buttonholes PreparationTo prepare the fabric Tips Blind HEM Zippers and Piping Patching Step ZIG-ZAGStitch Selection Triple straight stitchTriple zig-zag Remove the stitch plate MaintenanceCleaning the feed dog Cleaning and lubricating the hookProblem Cause Correction Trouble Shooting Guide