Husqvarna E10 manual Step ZIG-ZAG, Patching

Page 27

3-STEP ZIG-ZAG

Sewing on lace and elastic, darning, mending, ﬁnishing edges.

Set the machine as illustrated. (1)

Patching:

Place the patch in position and stitch around edges.

The stitch length can be shortened to produce very close stitches.

(A)

When mending tears, it is advisable to use a piece of backing fabric to reinforce. The stitch density can be varied by adjusting the stitch length. Begin by sewing over the center and then overlap on both sides. Depending on the type of fabric and damage, sew between 3 and 5 rows. (B)

To ﬁnish edges, stitch along the edge of the fabric.

Stitch length dial

27

Image 27

Contents E10 Important Safety Instructions Congratulations List of Contents Principal Parts of the Machine Page Accessories Fitting the SNAP-IN Accessory BOX For USA and Canada Connecting the Machine to Power SourceFoot control Sewing lightChanging the Bulb TWO-STEP Presser Foot Lever Adjust Presser Foot PressureRemoving the presser foot Attaching the Presser Foot SHANK/ AnkleAttaching the presser foot holder Attaching the presser footPlease Note Winding the BobbinInserting the Bobbin Inserting the Needle Threading the Upper Thread Thread Tension Bringing UP the Bobbin Thread Reverse Sewing Removing the FabricCutting the Thread NEEDLE, FABRIC, Thread Selection Guide Matching Needle / Fabric / ThreadStraight Stitching Straight stitching center needle positionStraight stitching right needle position Zigzag Stitching Function of stitch length dial while zigzagingStitch length dial HOW to SEW Buttonholes PreparationTo prepare the fabric Tips Blind HEM Zippers and Piping Patching Step ZIG-ZAGStitch Selection Triple straight stitchTriple zig-zag Remove the stitch plate MaintenanceCleaning the feed dog Cleaning and lubricating the hookProblem Cause Correction Trouble Shooting Guide