Husqvarna E10 manual Important Safety Instructions

Page 2

This houshold sewing machine is designed to comply with IEC/EN 60335-2-28 and UL1594

IMPORTANT SAFETY

INSTRUCTIONS

When using an electrical appliance, basic safety precautions should always be followed, including the following:

Read all instructions before using this household sewing machine.

DANGER - To reduce the risk of electric shock:

A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning.

Always unplug before relamping. Replace bulb with same type rated 10W (110V-120V), 15W (220-240V).

WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:

Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used by or near children and infirm persons.

Use this sewing machine only for its intended use as described in this manual. Use only attachments recommended by the manufacturer as contained in this manual.

Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the sewing machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment.

Never operate the sewing machine with any air openings blocked. Keep ventilation openings of the sewing machine and foot controller free from the accumulation of lint, dust, and loose cloth.

Keep fingers away from all moving parts. Special care is required around the sewing machine needle.

Always use the proper needle plate. The wrong plate can cause the needle to break.

Do not use bent needles.

Do not pull or push fabric while stitching. It may deflect the needle causing it to break.

Switch the sewing machine off (“0”) when making any adjustment in the needle area, such as threading needle, changing needle, threading bobbin, or changing presser foot, etc.

Always unplug sewing machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction manual.

Never drop or insert any object into any opening.

Do not use outdoors.

Do not operate where aerosol (spray) products are being used or where oxygen is being administrated.

To disconnect, turn all controls to the off (“0”) position, then remove plug from outlet.

Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

SAVE THESE INSTRUCTIONS

Image 2
Contents E10 Important Safety Instructions Congratulations List of Contents Principal Parts of the Machine Page Accessories Fitting the SNAP-IN Accessory BOX Sewing light Connecting the Machine to Power SourceFoot control For USA and CanadaChanging the Bulb Adjust Presser Foot Pressure TWO-STEP Presser Foot LeverAttaching the presser foot Attaching the Presser Foot SHANK/ AnkleAttaching the presser foot holder Removing the presser footWinding the Bobbin Please NoteInserting the Bobbin Inserting the Needle Threading the Upper Thread Thread Tension Bringing UP the Bobbin Thread Cutting the Thread Reverse SewingRemoving the Fabric Matching Needle / Fabric / Thread NEEDLE, FABRIC, Thread Selection GuideStraight stitching right needle position Straight StitchingStraight stitching center needle position Stitch length dial Zigzag StitchingFunction of stitch length dial while zigzaging To prepare the fabric HOW to SEW ButtonholesPreparation Tips Blind HEM Zippers and Piping Step ZIG-ZAG PatchingTriple zig-zag Stitch SelectionTriple straight stitch Cleaning and lubricating the hook MaintenanceCleaning the feed dog Remove the stitch plateTrouble Shooting Guide Problem Cause Correction