England's Stove Works 40-TRCPM, 10-CPM, 49-SCHPM operation manual Flue System, Through the Wall

Page 10

FLUE SYSTEM

Caution: Follow the pipe manufacturer’s installation instructions and directions for passing through combustible walls and ceilings.

Be sure to check local codes in your area.

NOTE: See the installation drawing later in this manual (Illustration 1).

This unit is equipped with a negative draft system that pulls combustion air through the burnpot and pushes the exhaust air out of the dwelling. If this unit is connected to the flue system other than the way explained in this manual, it will not function properly. For any of these installations, keep in mind that each elbow used reduces draft by up to 30%; it is good practice to add three feet (3’) of vertical rise for each elbow used. Example: After the 2nd elbow used, add six feet (6’) of vertical rise before terminating your vent pipe.

Corn Vent Pipe

The UL approved corn vent pipe that we recommend is a twist lock system; however, it is still recommended that high temperature silicone (our Part Number AC-RTV3) or aluminum duct seal tape be used at each joint. England’s Stove Works recommends the use of Dura-Vent twist-lock pipe (if you use other pipe, consult your local building codes and/or building inspectors, and secure each joint with at least three screws—see “Important Information” section). Do not use “B” vent gas pipe or galvanized pipe with this unit. The corn pipe is designed to disassemble for cleaning and should be checked several times during the burning season — corn vent pipe is not furnished with the unit and must be purchased separately. Do not install a flue damper of any kind in this system, and do not connect this unit to a flue system serving another heating appliance.

Through the Wall

To vent the unit through the wall, connect the pipe adapter to the exhaust motor adapter. If the exhaust adapter is at least eighteen inches (18”) above ground level, a straight section of corn pipe can be used to initially pass through the wall (see Illustration 1). Your dealer or our factory should be able to provide you with a kit that will handle most of this installation, which will include a wall thimble that will allow the proper clearances through a combustible wall. Once outside the structure, a three- inch (3”) clearance should be maintained to the outside wall and a clean out tee should be placed on the pipe that extends through the wall. We recommend a minimum of three feet (3’) of vertical pipe with a 90-degree turn away from the house. At this point, a one-foot (1’) section and horizontal cap will complete the installation (see Illustration 1).

A wall strap should be placed just below the last 90-degree section to make the system more stable. If you live in an area that has heavy snowfall, it is recommended the installation be taller than three feet (3’) to get above the snowdrift line.

The same type installation can be used if your stove is below ground level by adding the clean- out section and vertical pipe inside until ground level is reached. However, we recommend basement installation be performed only by a professional installer. For basement installations, a 3” (three inch) pipe and coupler must be used for Outside Combustion Air, and a minimum clearance of three feet (3’) must be maintained outside the dwelling from the ground to the Corn Vent Exhaust Pipe.

Call (800) 516-3636to inquire about the AC-33000 Through-the-Wall Kit or

Visit our web site at www.englanderstoves.com for ordering information!

10

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE

TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Model Numbers 10-CPM 49-TRCPM 49-SHCPM Must be maintainedLetter from our Technical Support department England’s Stove Works Technical Support Department 800Important Information Important Notice Unit Preparation Important Information Read Before OperatingPage Page Do not Connect to ANY AIR Distribution Duct or System Shelled Corn Burning Solid FuelsWood Pellets Cherry PitsFlue System Through the WallThrough the Ceiling Mobile Home InstallationOutside Air Outside Combustion Air Intake Floor Protection Freestanding Pellet/Corn/Multi-fuel InstallationFloor and Wall Protection Wall ProtectionOperating Instructions START- UP ProceduresSetting the Stirrer Bodily Injury can occurFuel not Feeding Correctly To remove the Stirrer for cleaning Changing from Pellets to Corn Fuel Change ProcedureChanging from Pellets to Cherry Pits Codes Operational NotesTechnical Support Department SHUT-DOWN Procedure From the Power SourceBox Parts Orders only Monroe, VA Questions Fax Daily Operation ASH Removal and Disposal Maintenance Semi-Weekly Ash MaintenanceAnnual Maintenance Ash PanMaintenance Removing Motor and Sprocket Replacing the Stirrer Drive MotorReplacing the Stirrer Drive Shaft Finish GasketsGlass Control Board Recommended Heat RangesCircuit Board Functions Component Operation Start Operation ENDThermostat Accessory ItemsAccessories and Options AC-109, AC-109BN Lip TrimReplacement Parts CPM-APSee Item numbers on Exploded Diagram for part location Adjusting your Hopper Lid Latch Solution Problem CauseImproper installation may cause a back draft Problem Cause Solution Page Warranty is not Transferable Page Warranty Registration for England’s Stove Works Unit Information

40-TRCPM, 10-CPM, 49-SCHPM specifications

England's Stove Works is renowned for its commitment to crafting high-quality wood stoves and pellet stoves, and three of their notable products are the 49-SCHPM, 10-CPM, and 40-TRCPM models. Each of these stoves embodies the brand's dedication to efficiency, durability, and performance, making them popular choices for both heating homes and providing a cozy ambiance.

The 49-SCHPM is a powerful pellet stove designed to heat large spaces. It features a spacious hopper that can hold up to 60 pounds of pellets, allowing for extended burn times of up to 80 hours on lower settings. The stove incorporates an easy-to-use digital control board and a built-in thermostat, providing users with precise temperature regulation. This model also boasts a sleek, contemporary design, making it suitable for modern homes while still delivering traditional warmth.

In contrast, the 10-CPM is a compact and efficient pellet stove, ideal for smaller homes or tight spaces. Despite its smaller footprint, it still offers impressive heating capabilities with up to 35,000 BTU output, making it a formidable option for anyone seeking an efficient heat source without sacrificing performance. The 10-CPM features a large viewing window, which enhances the aesthetic appeal and allows users to enjoy the mesmerizing flames. It is also equipped with an automatic ignition system, making it convenient and easy to start.

The 40-TRCPM model showcases England's Stove Works' dedication to versatility. This multi-fuel stove can efficiently burn both wood pellets and corn, allowing homeowners the flexibility to choose their fuel source based on availability and cost. With an output capacity of 40,000 BTU, it is built to dominate larger areas while maintaining a steady heat output. The unit features a sophisticated combustion system that maximizes fuel efficiency and minimizes emissions, aligning with environmentally sustainable practices.

All three models utilize advanced engineering and technology to ensure an optimal burning experience. They come equipped with efficient air circulation systems and adjustable airflow to promote complete combustion, which results in less smoke and creosote buildup. This not only enhances safety but also contributes to the longevity of each unit.

Overall, England's Stove Works has established a strong reputation for producing reliable, efficient, and aesthetically pleasing stoves. The 49-SCHPM, 10-CPM, and 40-TRCPM exemplify the brand's commitment to quality and innovation, making them solid choices for anyone looking to enhance their home's heating system.
Top Page Image Contents