England's Stove Works 40-TRCPM, 10-CPM, 49-SCHPM operation manual Important Notice

Page 4

12.Keep corn, pellets and all other combustible materials a safe distance from the unit.

13.This unit will require floor protection if installed on a combustible surface. The minimum floor protector for this unit is 36” x 48” which should give you at least six inches (6”) of protection at the rear and at each side, and six inches (6”) minimum in the front of the unit.

14.Horizontal runs should not exceed four feet (4’) with a maximum vertical flue height of thirty five feet (35’). At fifteen feet (15’), the pipe should be increased to four inch (4”) corn vent pipe.

15.This unit should be turned off and allowed to cool prior to cleaning. Any ashes should be kept in an airtight metal container and not disposed of until they are completely cooled.

16.Read the instructions thoroughly, including instructions concerning the digital control board, and save them for future reference.

17.Do not allow paint, chemicals or construction dust on or near your unit. Do not allow liquid or ANY foreign materials on or inside your unit. Shut your unit down and cover it when painting, construction or similar activity is taking place. Wipe and clean your unit after any construction is done in your home, or if any foreign material gets on or inside your unit. You may also need to remove the rear and side cover plates to your unit (unplug unit first) and vacuum and clean the motors and inside of your unit.

18.Improper gasket maintenance, including failure to replace gaskets, can cause air leaks resulting in smoke-backs.

19.Remember that, as with any appliance, there is user responsibility involved, including installation, operation and maintenance of this product. Be sure to check local codes, and call Technical Support at (800) 245-6489 if you have any questions.

20.Be sure to follow the directions of all manufacturers of third party products that you use, including exhaust pipe, etc. Never apply firestarter products (including gel) to a hot surface or hot coals.

21.Basement Installation: Basement installation should be performed only by a professional installer. For basement installations, a three inch (3”) pipe and coupler must be used for Outside Combustion Air, and a minimum clearance of three feet (3’) must be maintained from the ground to the corn vent exhaust pipe outside the dwelling. Keep in mind that each elbow used reduces draft by up to 30%; it is good practice to add three feet (3’) of vertical rise for each elbow used. Example: After the 2nd elbow used, add six feet (6’) of vertical rise before terminating your vent pipe.

22.DANGER! Do not open the door on this unit if the Stirrer is still moving! See instructions on “Setting the Stirrer” later in this manual. See burnpot installation pictures.

IMPORTANT NOTICE:

This unit must be properly installed to prevent the possibility of a house fire or “smoke- back.” The instructions must be strictly adhered to.

Do not use makeshift methods or material which may compromise the installation.

Your unit requires periodic maintenance and cleaning (refer to manual). Failure to maintain your unit may lead to a variety of problems, including but not limited to smoke spillage into the home. England’s Stove Works will not be liable for consequential or indirect damages to property or persons resulting from the use of this product.

4

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE

TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Model Numbers 10-CPM 49-TRCPM 49-SHCPM Must be maintainedLetter from our Technical Support department England’s Stove Works Technical Support Department 800Important Information Important Notice Unit Preparation Important Information Read Before OperatingPage Page Do not Connect to ANY AIR Distribution Duct or System Burning Solid Fuels Wood PelletsShelled Corn Cherry PitsFlue System Through the WallThrough the Ceiling Mobile Home InstallationOutside Air Outside Combustion Air Intake Freestanding Pellet/Corn/Multi-fuel Installation Floor and Wall ProtectionFloor Protection Wall ProtectionSTART- UP Procedures Setting the StirrerOperating Instructions Bodily Injury can occurFuel not Feeding Correctly To remove the Stirrer for cleaning Changing from Pellets to Corn Fuel Change ProcedureChanging from Pellets to Cherry Pits Codes Operational NotesTechnical Support Department SHUT-DOWN Procedure From the Power SourceBox Parts Orders only Monroe, VA Questions Fax Daily Operation Maintenance Semi-Weekly Ash Maintenance Annual MaintenanceASH Removal and Disposal Ash PanMaintenance Removing Motor and Sprocket Replacing the Stirrer Drive MotorReplacing the Stirrer Drive Shaft Finish GasketsGlass Control Board Recommended Heat RangesCircuit Board Functions Component Operation Start Operation ENDAccessory Items Accessories and OptionsThermostat AC-109, AC-109BN Lip TrimReplacement Parts CPM-APSee Item numbers on Exploded Diagram for part location Adjusting your Hopper Lid Latch Solution Problem CauseImproper installation may cause a back draft Problem Cause Solution Page Warranty is not Transferable Page Warranty Registration for England’s Stove Works Unit Information

40-TRCPM, 10-CPM, 49-SCHPM specifications

England's Stove Works is renowned for its commitment to crafting high-quality wood stoves and pellet stoves, and three of their notable products are the 49-SCHPM, 10-CPM, and 40-TRCPM models. Each of these stoves embodies the brand's dedication to efficiency, durability, and performance, making them popular choices for both heating homes and providing a cozy ambiance.

The 49-SCHPM is a powerful pellet stove designed to heat large spaces. It features a spacious hopper that can hold up to 60 pounds of pellets, allowing for extended burn times of up to 80 hours on lower settings. The stove incorporates an easy-to-use digital control board and a built-in thermostat, providing users with precise temperature regulation. This model also boasts a sleek, contemporary design, making it suitable for modern homes while still delivering traditional warmth.

In contrast, the 10-CPM is a compact and efficient pellet stove, ideal for smaller homes or tight spaces. Despite its smaller footprint, it still offers impressive heating capabilities with up to 35,000 BTU output, making it a formidable option for anyone seeking an efficient heat source without sacrificing performance. The 10-CPM features a large viewing window, which enhances the aesthetic appeal and allows users to enjoy the mesmerizing flames. It is also equipped with an automatic ignition system, making it convenient and easy to start.

The 40-TRCPM model showcases England's Stove Works' dedication to versatility. This multi-fuel stove can efficiently burn both wood pellets and corn, allowing homeowners the flexibility to choose their fuel source based on availability and cost. With an output capacity of 40,000 BTU, it is built to dominate larger areas while maintaining a steady heat output. The unit features a sophisticated combustion system that maximizes fuel efficiency and minimizes emissions, aligning with environmentally sustainable practices.

All three models utilize advanced engineering and technology to ensure an optimal burning experience. They come equipped with efficient air circulation systems and adjustable airflow to promote complete combustion, which results in less smoke and creosote buildup. This not only enhances safety but also contributes to the longevity of each unit.

Overall, England's Stove Works has established a strong reputation for producing reliable, efficient, and aesthetically pleasing stoves. The 49-SCHPM, 10-CPM, and 40-TRCPM exemplify the brand's commitment to quality and innovation, making them solid choices for anyone looking to enhance their home's heating system.
Top Page Image Contents