England's Stove Works 49-SCHPM Through the Ceiling, Outside Air Outside Combustion Air Intake

Page 11

The through-the-wall installation is the least expensive and simplest installation. In a through- the-wall installation you should be mindful of the snowdrift line, as well as dead grass and leaves. We recommend a three foot (3’) minimum vertical rise on the inside or the outside of the dwelling.

Through the Ceiling

When venting the stove through the ceiling, the pipe is connected the same as through the wall, except the clean out tee is always on the inside of the house, and a 3” adapter is added before the clean-out tee. You must use the proper ceiling support flanges and roof flashing supplied by the pipe manufacturer -- follow the pipe manufacturer’s directions and Illustration 1 in this manual. It is important to note that if your vertical runs of pipe are more than fifteen feet (15’) at this point, the corn vent pipe should be increased to four inches (4”) in diameter. Do not exceed four feet (4’) of pipe on a horizontal run, and do attempt to use the least number of elbows in the flue system. If an offset is used it is better to install a 45-degree elbow whenever possible. Please remember, installing elbows may inhibit your draft by up to 30% per elbow.

Outside Air (Outside Combustion Air Intake)

Outside air is mandatory for this unit to operate properly. This unit has been designed and tested with this connection, because so many homes are airtight and there is not adequate combustion air available inside the dwelling. The air intake pipe is located on the bottom side of the burnpot (from the rear) and measures 1 ½” inside diameter (I.D.). The connection can be made with a metal 1 7/8” I.D. coupler and pipe (see “Important Information” section of manual), and should exit through the wall. Be sure to secure the pipe to the unit with a clamp or aluminum tape. The outside end of the pipe should be covered (screened) to prevent foreign matter from entering the system. Our Outside Air Kit (Part Number PU-OAK) can be used. If the unit is located below ground level, you will need to run the pipe up and then outside the dwelling. NOTE: If the total run of the connection exceeds six feet (6’), if more than two elbows are used, or if a basement installation, use 3” metal pipe (and coupler) instead.

Mobile Home Installation

Secure the heater to the floor using the two holes in the pedestal. If the unit is on a combustible surface, you will need to drill matching holes in the floor protection that you choose (see Floor Protection section). Do not disturb the structural integrity of the home, and be sure the unit is permanently electrically grounded to the chassis of your home. Remember that outside combustion air is mandatory, and not to install the unit in a sleeping room of the home.

Important Notes Concerning Installation:

*IMPROPER INSTALLATION: The manufacturer will not be held responsible for damage caused by the malfunction of a stove due to improper venting or installation.

Call 800-245-6489 and/or consult a professional installer if you have any questions.

IMPORTANT: Improper hook-up (too much pipe, too many elbows, etc.) will cause the unit not to operate. Call Technical Support (800-245-6489) if you have questions about your hook-up or if your unit will not operate.

IMPORTANT SAFETY NOTE: If the unit or chimney connector pipe “glows” red (or white), the stove is over-fired. This condition could cause a house or chimney fire. Do not operate your unit too hot, or over-firing may result.

11

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE

TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Must be maintained Model Numbers 10-CPM 49-TRCPM 49-SHCPMEngland’s Stove Works Technical Support Department 800 Letter from our Technical Support departmentImportant Information Important Notice Important Information Read Before Operating Unit PreparationPage Page Do not Connect to ANY AIR Distribution Duct or System Cherry Pits Burning Solid FuelsWood Pellets Shelled CornThrough the Wall Flue SystemOutside Air Outside Combustion Air Intake Mobile Home InstallationThrough the Ceiling Wall Protection Freestanding Pellet/Corn/Multi-fuel InstallationFloor and Wall Protection Floor ProtectionBodily Injury can occur START- UP ProceduresSetting the Stirrer Operating InstructionsFuel not Feeding Correctly To remove the Stirrer for cleaning Changing from Pellets to Cherry Pits Fuel Change ProcedureChanging from Pellets to Corn Operational Notes CodesBox Parts Orders only Monroe, VA Questions Fax SHUT-DOWN Procedure From the Power SourceTechnical Support Department Daily Operation Ash Pan Maintenance Semi-Weekly Ash MaintenanceAnnual Maintenance ASH Removal and DisposalMaintenance Replacing the Stirrer Drive Shaft Replacing the Stirrer Drive MotorRemoving Motor and Sprocket Glass GasketsFinish Recommended Heat Ranges Control BoardComponent Operation Start Operation END Circuit Board FunctionsAC-109, AC-109BN Lip Trim Accessory ItemsAccessories and Options ThermostatCPM-AP Replacement PartsSee Item numbers on Exploded Diagram for part location Adjusting your Hopper Lid Latch Improper installation may cause a back draft Problem CauseSolution Problem Cause Solution Page Warranty is not Transferable Page Unit Information Warranty Registration for England’s Stove Works

40-TRCPM, 10-CPM, 49-SCHPM specifications

England's Stove Works is renowned for its commitment to crafting high-quality wood stoves and pellet stoves, and three of their notable products are the 49-SCHPM, 10-CPM, and 40-TRCPM models. Each of these stoves embodies the brand's dedication to efficiency, durability, and performance, making them popular choices for both heating homes and providing a cozy ambiance.

The 49-SCHPM is a powerful pellet stove designed to heat large spaces. It features a spacious hopper that can hold up to 60 pounds of pellets, allowing for extended burn times of up to 80 hours on lower settings. The stove incorporates an easy-to-use digital control board and a built-in thermostat, providing users with precise temperature regulation. This model also boasts a sleek, contemporary design, making it suitable for modern homes while still delivering traditional warmth.

In contrast, the 10-CPM is a compact and efficient pellet stove, ideal for smaller homes or tight spaces. Despite its smaller footprint, it still offers impressive heating capabilities with up to 35,000 BTU output, making it a formidable option for anyone seeking an efficient heat source without sacrificing performance. The 10-CPM features a large viewing window, which enhances the aesthetic appeal and allows users to enjoy the mesmerizing flames. It is also equipped with an automatic ignition system, making it convenient and easy to start.

The 40-TRCPM model showcases England's Stove Works' dedication to versatility. This multi-fuel stove can efficiently burn both wood pellets and corn, allowing homeowners the flexibility to choose their fuel source based on availability and cost. With an output capacity of 40,000 BTU, it is built to dominate larger areas while maintaining a steady heat output. The unit features a sophisticated combustion system that maximizes fuel efficiency and minimizes emissions, aligning with environmentally sustainable practices.

All three models utilize advanced engineering and technology to ensure an optimal burning experience. They come equipped with efficient air circulation systems and adjustable airflow to promote complete combustion, which results in less smoke and creosote buildup. This not only enhances safety but also contributes to the longevity of each unit.

Overall, England's Stove Works has established a strong reputation for producing reliable, efficient, and aesthetically pleasing stoves. The 49-SCHPM, 10-CPM, and 40-TRCPM exemplify the brand's commitment to quality and innovation, making them solid choices for anyone looking to enhance their home's heating system.
Top Page Image Contents