England's Stove Works 49-SCHPM, 10-CPM, 40-TRCPM operation manual Adjusting your Hopper Lid Latch

Page 29

Adjusting your Hopper Lid Latch

The seals around the top of the pellet hopper are important to safe and efficient operation of the unit. The latch installed on these units is designed to pull the hopper lid tight against this seal. Over the course of operation as these seals “wear in” and compress, the tension of the latch should be tested periodically, and adjusted if necessary.

To adjust the lid latch, the following tools will be needed; two ½ inch wrenches, or a ½ inch wrench and a ½ inch socket. Unit should be unplugged and cooled down, as with all maintenance.

In order to adjust the latch, first open the hopper lid and then lock the latch in its closed position. Then take the ½ inch wrench and loosen the nut closest to the latch. This nut is then adjusted closer to the lid itself to tighten the latch. After adjusting this nut to the desired location, hold this nut in place with the ½ inch wrench, the tighten down the holding nut on the end of the latch shaft with the

½inch socket or second wrench to hold the latching assembly in place

After tightening the latch, test the latch for proper tension by locking the lid down and lifting each

front corner of the lid. The lid should be firmly held down by the latch. Repeat the same procedure if the latch is still not tight enough.

Illustration 9

Hopper Lid Latch

Important: Hopper Lid Latch must be checked periodically and kept tight so the top is sealed to prevent back-burn.

29

IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING

CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.

ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE

TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.

Image 29
Contents Must be maintained Model Numbers 10-CPM 49-TRCPM 49-SHCPMEngland’s Stove Works Technical Support Department 800 Letter from our Technical Support departmentImportant Information Important Notice Important Information Read Before Operating Unit PreparationPage Page Do not Connect to ANY AIR Distribution Duct or System Wood Pellets Burning Solid FuelsShelled Corn Cherry PitsThrough the Wall Flue SystemOutside Air Outside Combustion Air Intake Mobile Home InstallationThrough the Ceiling Floor and Wall Protection Freestanding Pellet/Corn/Multi-fuel InstallationFloor Protection Wall ProtectionSetting the Stirrer START- UP ProceduresOperating Instructions Bodily Injury can occurFuel not Feeding Correctly To remove the Stirrer for cleaning Changing from Pellets to Cherry Pits Fuel Change ProcedureChanging from Pellets to Corn Operational Notes CodesBox Parts Orders only Monroe, VA Questions Fax SHUT-DOWN Procedure From the Power SourceTechnical Support Department Daily Operation Annual Maintenance Maintenance Semi-Weekly Ash MaintenanceASH Removal and Disposal Ash PanMaintenance Replacing the Stirrer Drive Shaft Replacing the Stirrer Drive MotorRemoving Motor and Sprocket Glass GasketsFinish Recommended Heat Ranges Control BoardComponent Operation Start Operation END Circuit Board FunctionsAccessories and Options Accessory ItemsThermostat AC-109, AC-109BN Lip TrimCPM-AP Replacement PartsSee Item numbers on Exploded Diagram for part location Adjusting your Hopper Lid Latch Improper installation may cause a back draft Problem CauseSolution Problem Cause Solution Page Warranty is not Transferable Page Unit Information Warranty Registration for England’s Stove Works

40-TRCPM, 10-CPM, 49-SCHPM specifications

England's Stove Works is renowned for its commitment to crafting high-quality wood stoves and pellet stoves, and three of their notable products are the 49-SCHPM, 10-CPM, and 40-TRCPM models. Each of these stoves embodies the brand's dedication to efficiency, durability, and performance, making them popular choices for both heating homes and providing a cozy ambiance.

The 49-SCHPM is a powerful pellet stove designed to heat large spaces. It features a spacious hopper that can hold up to 60 pounds of pellets, allowing for extended burn times of up to 80 hours on lower settings. The stove incorporates an easy-to-use digital control board and a built-in thermostat, providing users with precise temperature regulation. This model also boasts a sleek, contemporary design, making it suitable for modern homes while still delivering traditional warmth.

In contrast, the 10-CPM is a compact and efficient pellet stove, ideal for smaller homes or tight spaces. Despite its smaller footprint, it still offers impressive heating capabilities with up to 35,000 BTU output, making it a formidable option for anyone seeking an efficient heat source without sacrificing performance. The 10-CPM features a large viewing window, which enhances the aesthetic appeal and allows users to enjoy the mesmerizing flames. It is also equipped with an automatic ignition system, making it convenient and easy to start.

The 40-TRCPM model showcases England's Stove Works' dedication to versatility. This multi-fuel stove can efficiently burn both wood pellets and corn, allowing homeowners the flexibility to choose their fuel source based on availability and cost. With an output capacity of 40,000 BTU, it is built to dominate larger areas while maintaining a steady heat output. The unit features a sophisticated combustion system that maximizes fuel efficiency and minimizes emissions, aligning with environmentally sustainable practices.

All three models utilize advanced engineering and technology to ensure an optimal burning experience. They come equipped with efficient air circulation systems and adjustable airflow to promote complete combustion, which results in less smoke and creosote buildup. This not only enhances safety but also contributes to the longevity of each unit.

Overall, England's Stove Works has established a strong reputation for producing reliable, efficient, and aesthetically pleasing stoves. The 49-SCHPM, 10-CPM, and 40-TRCPM exemplify the brand's commitment to quality and innovation, making them solid choices for anyone looking to enhance their home's heating system.