Enviro 1200-V Insert, Venice, 1700-V Insert owner manual Type of protection Modified Clearance

Specifications

CLEARANCES TO COMBUSTIBLES - 1200-V INSERT:

Table 2: 1200-V Insert Clearance to Combustibles.

A Minimum clearance to an unshielded side wall		10” (254 mm)
B	Minimum clearance to an unshielded 8” (203	21” (533 mm)
	mm) mantel
			����
C Minimum top facing (protruding 3⁄4” [19 mm])		171⁄2” (445 mm)		�	�
	clearance		��������
	clearance			�
D	Minimum side facing (protruding 3⁄4” [19 mm])	1” (25 mm)			�
E † From front of door opening to edge of floor		USA 16” (406 mm)
	protection	CND 18” (450 mm)			�
F	† From side/back of unit to edge of floor	USA 6” (152 mm)		�
	protection	CND 8” (200 mm)

†FLOOR PROTECTION:

If unit is raised 0” - 2” (0mm-51mm); 1” (25mm) non-combustible material with k value = 0.84 or equivalent.

If unit is raised 2” - 8” (51mm-203mm); 1⁄2” (13mm) non-combustible material with k value = 0.84 or equivalent. If unit is raised greater than 8” (203 mm) or more; any non-combustible material can be used.

Table 3: Reduction in (B) Minimum Clearance from 1200-V to 8” (203 mm) Mantel.

Type of protection	Modified Clearance
A minimum of .013” (0.33mm) sheet metal spaced out 1” (25mm) by non-	101⁄2” (267 mm)
combustible spacers.
Ceramic tiles, or eqivalent non-combustible material on non-combustible	14” (357 mm)
supports and spaced out 1” (25mm) by non-combustible spacers.
Ceramic tiles, or eqivalent non-combustible material on non-combustible
supports with a minimum of .013” (0.33mm) sheet metal spaced out 1”	101⁄2” (267 mm)
(25mm) by non-combustible spacers.

NOTES:

(1)Mantel protection must have at least 3” (75mm) edge clearance on all sides, except as provided in Note 4.

(2)If an adhesive is used to support non-combustible material, it shall not lose adhesive qualities at temperatures likely to be encountered and shall not contribute a significant combustible load.

(3)Heat shield mounting hardware attached to combustible materials must be placed at the lateral extremities of the shield.

(4)Minimum clearance to unprotected walls and ceilings must be maintained.

Table 4: 1200-V Insert Minimum Fireplace Size.

	Masonry	Zero Clearance
Minimum Depth	131⁄2” (343 mm)	14” (279 mm)
Minimum Width at back of fireplace	223⁄8” (568 mm)	23” (584 mm)
Minimum Width at front of fireplace	27” (686 mm)	271⁄4” (692 mm)
Minimum Width at front of fireplace to include shroud	333⁄4” (857 mm)	34” (864 mm)
Minimum Height	191⁄4” (489 mm)**	20” (508 mm)
	or 193⁄4” (502 mm)

**If the masonry lintel height is only 191⁄4” (489 mm) to 193⁄4” (502 mm) refer to INSTALLATION - MODIFICATIONS FOR

INSTALLATION WITH 191⁄4” (489 MM) HIGH LINTEL - INSERT

11