Enviro 1200-V Insert, Venice, 1700-V Insert owner manual Cast

Installation

The flue collar is removable for installations

into fireplaces with low openings.

a)

Remove

the

rear two (2) secondary

air

tube

and

C-Cast Ceramic Baffles,

if

installed (see C-CASTCERAMIC BAFFLE

INSTALLATION). Remove the secondary air

tubes by placing a screwdriver (any style

except flat head) into one of the air holes

USA 16” (406 mm)

and tapping it with a hammer/mallet to

the left.

CND 18” (450 mm)

b)

Unscrew the two (2) nuts on top of the

Floor Protection

8"

(203 mm)

inside of the firebox, using a 9/16” wrench

Masonry Fireplace

Combustible Floor

or socket (see Figure 13). The Flue Collar

Figure 11: Insert Installation into existing fireplace without

Clamps will slide off the bolts.

hearth.

c)

Pull the removable flue collar off the top

of the unit.

d)

Attach the flue collar to the venting pipe

using sheet metal screws.

e)

Push the unit into place while trying to

keep the collar attached to venting close

to the opening on the top of the unit.

Vent pipe

USA 16” (406 mm)

CND 18” (450 mm)

Collar Puller

Masonry Fireplace

Combustible Floor

1" (25mm)

Removable

Non-Combustible Board (K 0.84)

Flue Collar

Figure 12: Insert Installation into existing floor level

Gasket

masonry fireplace.

f)

Place the Collar Puller, over the two bolts of the Flue

Collar and pull it into place (see Figure 14). Ensure that

Firebox Top

the bolts are to the left and right of the hole. If they are

not, the front secondary air tube will need to be removed

Cut-away

in order to install or remove the C-Cast Ceramic Baffles.

g) Slide the Flue Collar Clamps and washers over the bolts,

and screw the nuts back onto the bolts.

Flue Collar Clamp

h) Re-install C-Cast Ceramic

Baffles and

the rear

two

Washer

(2)

secondary

air

tube

(see

C-CAST

CERAMIC

BAFFLE

Nut

INSTALLATION).

3. There are four (4) leveling legs (shown in Figure 15), two

Figure 13: Attaching removable flue collar.

(2) on each side, one at the back and one at the front of the

unit. Adjust the legs using a 3⁄8” wrench to ensure the unit is

stable.

17