Parts and Accessories

Service Parts available from your local Envirogas Dealer

Burner Control Assembly	Convection Blower
Natural Gas Pilot Assembly	Light Bulb Holder
Propane Pilot Assembly	Light Switch (momentary)
Door Bolt	Fan Controller
Relief Door Gasket	Log Set (with Embers)
Regulating Valve	Thermocouple
Piezo Igniter	Embers
Burner Switch	Thermopile
B-vent Spill switch 220°	Door Gasket
Orifice Blank	Convection Fan Sensor 120 F (49C)

Accessories

Gold trim Package

Low Voltage Thermostat

REMOVING or LUBRICATING THE BLOWER

The blower should be lubricated every 12 mos.

1. Turn the unit off and remove the log set.

2. Remove the burner tray assembly by removing the screw on either side of the tray, between the front and rear burners. Lift the tray out. Remove the brick liner by undoing the screw on either side and sliding the panel out.

3.Remove the 4-5/16” bolts that hold the blower mounting plate to the back firewall.

Use a light lubricating oil on screws before removal.

4.Carefully pull the blower assembly into the firebox, exposing the blower lubricating holes (located on the top of the motor housing on either side of the label). Add 2 drops of SAE 20 oil.

5.If removal of the blower is necessary, disconnect the blower leads from the harness. Remove the blower.

6.To re-install, check mounting plate gasket and reverse steps 1 through 4.