Enviro EG 40 B owner manual Safety Precautions, General, For Your Safety

Page 2

SAFETY PRECAUTIONS

FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" STOVE, PLEASE,

CAREFULLY READ THE FOLLOWING INFORMATION:

GENERAL

Installation and repair should be done by a qualified service person. The appliance should be inspected before use and at once least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is imperative that control compartments, burners and circulating air passageways of the appliance be kept clean.

Due to high temperatures, the appliance should be located out of high traffic areas and away from furniture and draperies.

Children and adults should be alerted to hazards of high surface temperatures and should stay away to avoid burns or clothing ignition.

Young children should be carefully supervised when they are in the same room as the appliance.

Clothing or other flammable material should not be placed on or near the appliance.

All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in this manual first. Consult the building authority having jurisdiction to determine the need for a permit prior to commencing the installation.

NOTE Failure to follow these instructions could cause a malfunction of the fireplace, which could result in death, serious bodily injury, and/or property damage.

Failure to follow these instructions may also void your fire insurance and/or warranty.

FOR YOUR SAFETY:

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

Installation must conform to local codes or, in the absence of local codes with the current CAN 1-B 149 installation code in Canada or the current National Fuel Gas Code ANSI Z223.1 in the USA.

To prevent injuries do not allow anyone who is unfamiliar with the operation to use the stove.

Always keep the appliance area clear and free of combustible materials, gasoline and other flammable vapors and liquids.

These appliances should not be used as a drying rack for clothing or for hanging Christmas stockings or decorations.

Due to the paint curing on the stove a faint odor and slight smoking will likely be noticed when the stove is first used. Open a window until the slight smoking stops. Always connect this gas stove to a chimney and vent to the outside of the building envelope. Never vent to another room or inside a building. Make sure you use the vent pipe that is specified. Make sure that the vent is properly sized and is of adequate height to provide the proper draft. Inspect the venting system annually for blockage and any signs of deterioration.

WARNING: Do not operate with cracked or broken glass. Under no circumstances should this appliance be modified. Parts that have to be removed for servicing must be replaced prior to operating this appliance. Only parts supplied by Envirogas should be used in this appliance and replacement should only be performed by a licensed or qualified service person.

Never use solid fuels such as wood, paper, cardboard, coal, or any other flammable liquids etc., in this appliance.

Do not use this heater if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of the control system and any gas control, which has been under water.

Do not abuse glass by striking or slamming door shut.

2

Image 2
Contents S H E R W O O D I N D U S T R I E S L T D For Your SafetyWhat to do if YOU Smell GAS General Safety PrecautionsFor Your Safety Code Approvals Table of ContentsAssembly Instructions Clearances Deciding Where to Locate Your StoveDimensions Vent Terminal Clearances Flue GAS Spill Switch VentingUsing AN Existing Chimney Manufacturers General Venting GuidelinesInstallation of LOG SET and Embers Installing the Glowing EmbersLighting Instructions For Your Safety Read Before OperatingOperating Instructions What to do if YOU Smell GASTo Replace Door and Glass Assembly Maintenance and TechnicalCleaning of Glass For Cleaning the Inside of the FireboxTrouble Shooting Problem Possible Cause SolutionOrifice SIZES, Pressure and BTU’S Never USE AN Open Flame for Leak TestingGAS Line Connection Installing Remote Thermostat or Wall Switch ElectricalParts and Accessories Service Parts available from your local Envirogas DealerFuel Type Conversion To the Dealer WarrantyTo a Maximum of Seven Years To the DistributorParts List Exploded EG 40 Door and Burner AssembliesEC-031 Gasket EG 40 Freestanding Installation Data Sheet Model EG