Enviro EG 40 B owner manual Installation of LOG SET and Embers, Installing the Glowing Embers

Page 8

INSTALLATION OF LOG SET and EMBERS

INSTALLING THE GLOWING EMBERS

A bag of ceramic fiber embers is provided for use on the front burner ember tray.

CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other foreign materials on the burners may create dangerous conditions.

If over time, through cleaning and servicing, these embers require replacement, contact your nearest ENVIROGAS dealer for replacement embers.

Gently remove the ember material from the plastic bag. Spreading pieces evenly across the front and rear of the ember tray.

Do not pack down, leave embers loose.

DO NOT PLACE EMBERS ON THE REAR BURNER.

CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED

INSTALLING THE LOG SET

Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log in its proper position to insure safe, optimum operating conditions.

1.Open the front door.

2.Place the log set all the way into the back of the firebox resting on the log supports.

3.Close the door and tighten securely.

Upon the first light up, watch for ignition to all burner ports. If a long delay is noted:

a) First, wait for the appliance to cool down

b) Open the front door of the appliance.

c) Check to carefully reposition the embers making sure that burner ports are not plugged solid or blocked.

(See adjusting the venturi section to adjust air for proper flame).

8

Image 8
Contents S H E R W O O D I N D U S T R I E S L T D For Your SafetyWhat to do if YOU Smell GAS General Safety PrecautionsFor Your Safety Code Approvals Table of ContentsAssembly Instructions Clearances Deciding Where to Locate Your StoveDimensions Vent Terminal Clearances Flue GAS Spill Switch VentingUsing AN Existing Chimney Manufacturers General Venting GuidelinesInstallation of LOG SET and Embers Installing the Glowing EmbersFor Your Safety Read Before Operating Operating InstructionsLighting Instructions What to do if YOU Smell GASMaintenance and Technical Cleaning of GlassTo Replace Door and Glass Assembly For Cleaning the Inside of the FireboxTrouble Shooting Problem Possible Cause SolutionOrifice SIZES, Pressure and BTU’S Never USE AN Open Flame for Leak TestingGAS Line Connection Installing Remote Thermostat or Wall Switch ElectricalParts and Accessories Service Parts available from your local Envirogas DealerFuel Type Conversion Warranty To a Maximum of Seven YearsTo the Dealer To the DistributorParts List Exploded EG 40 Door and Burner AssembliesEC-031 Gasket EG 40 Freestanding Installation Data Sheet Model EG