Installing the Main Remote Control:
WARNING: Field wiring connections and electrical grounding must comply with local codes, or in the absence of local codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, Canadian Electrical Code, CSA C22.1 Part 1.
Remote Control Installation
NOTICE: Extension cable can be any
Do Not apply sealant to the remote control cable.
It is not recommended to have wiring exposed.
Connecting the MAIN
● Drill a 1” (2..5 cm) to |
at the proposed control location.. |
● Install the extension cable between the |
location of the remote control and the |
water heater.. |
● Remove the base plate from the control.. |
● Feed the remote control extension cable |
through the central hole in the base plate.. |
● Fix the base plate to the wall using |
suitable screws and wall anchors.. |
Ensure the projections on the base |
plate are pointing upward.. |
Connecting the remote control to the water heater:
●Ensure that the power to the water heater has been disconnected..
●Loose the 3 screws located on the remote control connection cover made of white plastic (see the diagram on the left top)..
●Connect the remote control extension cables from the remote control with the remote control connection terminals (see the diagram on the left bottom)..
NOTICE: The remote control wire connection terminals are not polarity sensitive.
Remote Control Connection Cover
Remote
Control
Connection
Terminals
Gas Valve
● Connect the remote control cables to the |
extension cable from the water heater.. |
● Place the remote control over the |
base plate.. Ensure the projections in |
the base plate fit into the housings in |
the remote control.. |
● Fix the control to the base plate at the |
bottom of the remote control using the |
screw provided.. |
● Proceed to “Connecting the remote |
control to the water heater”, to complete |
installation.. |
●Firmly tighten the terminal screws..
●Secure the remote control extension cable on the hook located on the side of the remote control connection base..
●Tighten the 3 screws and attach the remote control connection cover to the water heater..
●Switch on the power supply to the water heater..
●Ensure proper operation of the remote control and water heater..
|
| Projections | |
Remote | Extension | Wall | |
Control | |||
Cable | |||
| Penetration | ||
|
|
Remote Control |
| Suitable |
Connection Cable |
| |
| Wall Anchors | |
|
| |
| Control | Base Plate |
| Screw | |
| Screws | |
|
|
20