Rheem RUTG-66DV, P), PH-25RDVS, RMTG-66DV, ECO-180DV warranty Water Temperature Setting…

Notice: The remote control cannot be turned on when water is flowing or circulating through the water heater..

Notice: Display shows °F only..

Water Temperature Setting…

Maximum water temperature occurs while			control(s) should be used..
the burner is on.. To determine the water			The hottest temperature water will be at the
temperature, turn on a hot water faucet and
			hot water faucet closest to the water heater..
place a thermometer in the water stream..
Water temperature at the faucet may vary			Always remember to test the water
depending on season and length of pipe			temperature with your hand before use and
from the water heater..			remember that hotter water increases the risk
The factory setting of the remote control			of scald injury..
temperature range is between 100°F (38°C)			Always supervise young children or others
and 120°F (49°C)..			who are incapacitated..
The remote control is factory preset to 100°F			The water heater is equipped with a device
(38°C).. To turn the remote control ON or			that will shut off the gas supply to the burner
OFF, press the POWER button..			if the water heater exceeds normal operating
To adjust the temperature to a required setting,			temperatures.. Refer to the “Before You Call
			For Service” section located near the back of
press the UP arrow temperature button..
			this manual, or contact your dealer..
Pressing the UP or DOWN temperature
			! WARNING: Should overheating
adjustment buttons will change the
			occur or the gas supply fail to shut off,
temperature set point..
			turn off the manual gas control valve
The temperature set point on the remote			to the appliance.
control cannot be increased above 112°F			If the water heater has been subjected to
(44°C) when a hot water faucet is in the
			fire, flood, physical damage, or has been
open position..
			under water, turn off the manual gas shut-off
Notice: The factory setting allows operating			valve(s), and do not operate the water heater
temperatures between 100°F (38°C) and			again until it has been checked by qualified
120°F (49°C).. Temperatures of 85°F (29°C)			personnel..
and above 120°F (49°C) can be achieved			Notice: The water heater may not operate
with the MAIN (UMC-117) remote control..			with a small water flow.. In such case, increase
Temperatures of 85°F (29°C) can be			the water flow.. If water heater still does not
achieved with the Bath (USC-117 or			operate and hot water faucet is completely
USC2-117) remote control.. Only qualified			open, increase the temperature setting on the
service personnel should perform this			remote control..
adjustment.. Only factory authorized remote
In Use Indicator				Priority Indicator
(Lit during operation)
LED Display	PRIORITY			Temperature
(Displays water		°F			Adjustment
temperature and error					Buttons
codes)					ON/OFF
			POWER
			ON/OFF		Indicator

		Higher (Hotter)									Lower (Cooler)
85	100 102 104 106 108 110 112 114 116 118 120*											125 130 135 140				°F
29	38	39	40	41	42	43	44	46	47	48	49*	52	54	57	60	°C

* Temperatures 85°F (29°C) and above 120°F (49°C) can be achieved with the
MAIN (UMC-117) remote control.. See page 34 and 35 for maximum and	27
minimum temperature adjustment..