GE GN75DNSRSA, GP94DNSRSA Vent Products, Flue Installation Concentric Venting, Product Parts

Page 20

Installation Instructions

VENTING INSTRUCTIONS (cont.)

FLUE INSTALLATION – CONCENTRIC VENTING

To adjust the condensate collector position:

1Loosen the 4 screws at the rear bracket.

2Slide the bracket away from the female vent top.

3Remove the 4 screws attaching the female vent top to the water heater.

4Lift up the female vent top and reposition as desired (or replace with a male vent top).

5Install the 4 screws at the vent top and tighten the 4 screws at the bracket.

Bracket

Secure the first vent component to the water heater with one self-tapping screw at the hole located above the condensate collector.

VENTING INSTRUCTIONS (cont.)

VENT PRODUCTS

Listed and Tested Vent Products for GN75DNSRSA, GN94DNSRSA and GP94DNSRSA (concentric venting)

MANUFACTURER

PRODUCT

PARTS

Ubbink

RoluxVent System

Refer to the manufacturer’s technical literature

 

 

for specific part numbers and instructions.

Heat-Fab

Saf-T Vent SC system

At the time of printing, these manufacturers’

Metal-Fab

Corr/Guard Vent/

products were listed and tested vent products.

 

Air Intake System

 

The installer must verifyprior to installation if

 

 

 

 

proper venting is used. For up-to-date approved

 

 

vent materials, see http://directories.csa.international.org/

 

 

for the CSA Certificationrecord with approved vent materials.

 

 

 

VENT MANUFACTURERCONTACTINFORMATIONFOR INSTALLATIONINSTRUCTIONSAND PARTSLIST

Ubbink

Heat-Fab

Metal-Fab Inc.

Telephone: 888.HOTWTER

Telephone: 1.800.772.0739

Telephone: 1.800.835.2830

(888.468.9837)

 

Web Site: www.heatfab.com

1.316.943.2351

 

 

 

Web Site: www.metal-fabinc.com

20

Image 20
Contents Before Beginninginstallation Safety PrecautionsFor Your Safety Models GN75DNSRSA, GN94DNSRSA, GP94DNSRSAInstallation Instructions Safety PrecautionsParts Provided Tools YOU will NeedDescription DimensionsGN75/GN94/GP94DNSRSA Planning for Venting INTAKE/EXHAUST GuidelinesFlue Terminal Clearances Flue Terminal Clearances Ansi Z21.10.3 CSAAdditional Clearances Vent Terminal Condensate Drain Flue Installation Condensate DrainHorizontal Termination with Planning for Plumbing Shown with optional pipe coverMounting the Water Heater Clearances for Water HeaterCorrosive Atmospheres Mounting the Water Heater Mounting the WaterheaterGAS Piping GAS PipingConnecting the Water Heater to the GAS Supply Water Piping Water PipingPressure Relief Valve Internal BUILT-IN Freezer ProtectionConnecting the Water Heater to the Water Supply Supplemental Freeze ProtectionRecommended Piping for Basic Installation KEYFreeze Protection For External Piping Electrical Connection Information Electrical RequirementsVenting Instructions Venting InstructionsCondensate Maximum Vent LengthProduct Parts Flue Installation Concentric VentingVent Products High Altitude Installations GuidelinesRemote Controller Installation ConfigurationsLocation Mounting the ControllerInstallation Checklist Cleaning the Inlet FilterCleaning the Inlet Filter Outlet Flow Data Technical DataPressure Drop Curve Ladder Diagram Page