GE GN75DNSRSA, GP94DNSRSA, GN94DNSRSA warranty Planning for Venting, INTAKE/EXHAUST Guidelines

Installation Instructions

PLANNING FOR VENTING

INTAKE/EXHAUST GUIDELINES

Refer to the specific instructions on your vent	• Venting should be as direct as possible with
product for additional installation requirements.	a minimum number of pipe fittings.
• This water heater is a direct vent water heater and	• Vent diameter must not be reduced.
therefore is certified and listed with the vent system.	• Do not connect the venting system with
You must use vent components that are certified
	an existing vent or chimney.
and listed with the water heater model. See
	• Do not connect vent with the vent pipe of any other
approved venting list on page 20.
• Do not combine vent components from different	water heater or appliance.
	• Vent connections must be firmly pressed together
manufacturers.
• The vent system must vent directly to	so that the gaskets form an air-tight seal.
	• The vent piece connected to the water heater must
the outside of the building and use outside
air for combustion.	be secured with one self-tapping screw.
• Every vent connection must be accessible for	• Refer to the vent pipe manufacturer’s instructions
inspection, cleaning and replacement.	for component assembly instructions.
• Avoid dips or sags in horizontal vent runs by	• It is recommended to install an optional inlet screen
installing supports per the vent manufacturer’s	to minimize blockage and maintenance from debris.
instructions.	See page 20.
• Support horizontal vent runs every four feet
and all vertical vent runs every six feet or in
accordance with local codes.

5