In Service Display
SU MO TU WE TH FR SA DAYS
Time/Day
Regeneration Time
Salt Amount
Capacity
Hardness
SU MO TU WE TH FR SA DAYS
Time/Day
Regeneration Time
Salt Amount
Capacity
Hardness
Logix 764 Electronic Multi-Tank - "A" Alternating Control:
Service display — The number of the Tank in Service (small digit next to CPH position) and Alternating Capacity Remaining and Flow Rate with Faucet icon of Tank in Service
Logix 764 Electronic Multi Tank - "P" Parallel Control:
Service Display — alternating three items
Capacity remaining for Tank 1 with digit "1" displayed Capacity remaining for Tank 2 with digit "2" displayed
System Flow Rate (Tank 1 + Tank 2 added) with Faucet icon
Logix 764 Electronic Multi Tank — "L" Lock Out Control
Service Display — Alternating Capacity Remaining and Flow Rate with Faucet icon "L” displayed indicating lockout signal is active. Blinking "L" and Lock icon if lockout signal is active and control is ready to perform regeneration.
Note: The faucet icon is displayed on all the Logix 764 controls when there is flow. The 764 will show the faucet icon when the flow rate is displayed, even if the flow rate is zero. If the flow rate is zero, the faucet will turn off when the capacity is displayed.
Programming Overview
The 764 control includes multiple program levels that allow the Water Treatment Professional to customize the system for many water conditions. Additionally, historical data can be viewed allowing quick and easy troubleshooting. In most cases Level I programming is all that is required to set up the water conditioning system for proper operation. A brief description of each program level is listed below.
Level I Used to program control for normal applications.
Level II
Level Ill
Level IV History
Note: If a button is not pushed for thirty seconds, the control returns to normal operation mode.
Level I Programming
The 764 control can be quickly programmed by following the sequential procedure in the section “Placing Water Conditioning System Into Operation”. Level I program parameters are those that can be accessed by pressing the UP or DOWN buttons.
•Resin Volume Setting: Set to match the volume (cubic feet) of resin in the mineral tank.
•Time of Day: Includes PM indicator. Can be set to display as a
•Day of Week: Set to actual day of the week.
•Time of Regeneration: Fully adjustable. Default is 2:00 AM.
•Days Override: Range 0.5 to 99 days. Leave at 0 to disable.
•Salt Dosage: Set at pounds of salt per cubic foot of resin in the conditioner tank.
Note: When the control is set up for a
22