LOCAL CODES
UNPACKING
PRODUCT
FEATURES
INSTALLING HEATER
6
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of the following:
•National Fuel Gas Code ANSI Z223.1, also known as NFPA 54 *
•National Electrical Code ANSI/NFPA 70 *
*Available from: American National Standards Institute, Inc. 1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
1.Remove heater from carton.
2.Remove all protective packaging applied to heater for shipment.
3.Check heater for any shipping damage. If heater is damaged, promptly inform dealer where you bought heater.
Piezo Ignition System
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
Thermostatic Heat Control
This heater has a thermostat sensing bulb and a control valve. This results in the greatest heating comfort. This can also result in lower gas bills.
WARNING
A qualified service person must install heater and venting system. Have them inspect heater before use and at least annually. Follow all local codes.
NOTICE
This heater must be electrically grounded if equipped with blower. Follow all local codes. In the absence of local codes, follow the National Electric Code, ANSI/NFPA 70.
CHECK GAS TYPE
Use only propane gas. If your gas supply is not propane, do not install heater. Call dealer where you bought heater for proper type heater.
INSTALLATION ITEMS
Before installing heater, make sure you have all items below.
• | external regulator (supplied by | • | test gauge connection * (see |
| installer, see page 11) |
| Figure 7, page 12) |
• | piping (check local codes) | • | sediment trap |
• | sealant (resistant to propane gas) | • | tee joint |
• manual shutoff valve * | • pipe wrench | ||
• | ground joint union | • | venting materials |
*An A.G.A.
100352