Genie 3064H manual Opener Features, Safety Features

Page 3

OPENER FEATURES

INTELLICODE® 2 Access Security System

A new generation superior encryption system that enhances the security of the door opener by continuously changing the access code each time the remote is used. The door opener responds to each new code only once. An access code copied from a working system and tried again will not control the door opener.

Wall Console, Series III

Operates door opener from inside garage. The Wall Console has an Indicator Light with: Open/Close, Sure-Lock™, and Independent Light Control buttons.

and Car2U® compatible. Refer to the programming instructions on page 10 and then follow the HomeLink® or Car2U® instructions in your car owner’s manual.

SAFETY FEATURES

Safe-T-Beam® (STB) Non-Contact Reversing System

Puts an invisible beam across the door opening. The door stops and reverses to the full open position if anything passes through the beam. LED indicator lights on the powerhead and on the STBs provide a self diagnostic code if an operational problem exists.

Safe-T-Reverse® Contact Reversing System

Automatically stops and reverses a closing door within two seconds of contact with an object.

Automatic ForceGuard™ Control

Automatically sets the force required to fully open and close the door for maximum safety.

Watch Dog™ Monitoring System

Monitors the Safe-T-Beam® system to ensure proper functionality and will automatically stop and reverse a closing door if a problem is detected.

Manual Emergency Release

Manually releases door from door opener. Used during a power failure or other emergency to allow manual opening and closing of door.

SmartSet™ Electronic Programming

Easily adjust the programming to reduce opening speed to a desired rate, vary limits and force, and program new remotes.

Automatic Lighting System

Two bulb lighting system supplies up to 200 Watts of light for safer evening exits and entries. Turns ON when door is activated and automatically turns OFF 4 minutes later.

Integrated Motion Detection (Not available on all models)

Select units have motion detection built into the powerhead. Lights automatically turn ON when motion is detected for much safer movement through the garage. Lights will turn OFF after 4 minutes of no motion.

©2010 The Genie Company

12/2010

3

Image 3 Contents
Operation and Maintenance Manual Prevention Potential HazardSafety Features Opener FeaturesTable of Contents Infrared Protection Function Important Installation InstructionsProgramming Limits & Force Both LEDs flash Blue Go OFF PressSee long Blue LED flashing Press and Hold until door is Fully Open then ReleaseTest AdjustmentSee both LEDs Flash Blue See both LEDs OFF Program Intellicode 2 Remote to PowerheadIntelliCode 1 remotes See round Blue LED come onSee long Purple LED flashing Genie IntelliCode 1 wireless keypadGenie IntelliCode 1 remote See oneReference Powerhead & Rail Assembled View Typical Sectional Door Installation Typical ONE Piece Door Installation Overview of Powerhead Controls On powerheadProgramming Buttons location Simultaneously on Overview Remotes and OptionsHold Press both2010 IntelliCode Intellicode FeaturesUse this New IntelliCode 2 openersTransmitter Compliance Statement Maintenance & TroubleshootingDoor Balance Spring Tension Routine Monthly MaintenanceAdjustment Safe-T-Beam System Check Door balance Contact reverseShuttle ENGAGE/DISENGAGE Disconnect power to door openerReset OPEN/CLOSE Travel Limit Change Light BulbsControls door opener lights from inside garage Wire routingWall Console Overview Open and closes door from inside garageThis area left blank Remote Battery ReplacementAdjustment Guide Speed Settings Change Speed SettingPowerhead LEDs Round LED Long LED Force Level LED indicator colors Adjustment Guide Force SettingsChange Force Setting Down Force settings within the available rangeTroubleshooting Guide Operation Powerhead LED Possible Problem Solution Opening Cover May Cause Electric Shock Disconnect power from opener prior to removing coverTrilo