Genie 3064H manual Press, See long Blue LED flashing, Both LEDs flash Blue Go OFF

Page 7

©2010 The Genie Company

6

PRESS and

RELEASE

OGRAM
PR		—
	SET	—
	SET

SEE long Blue LED flashing

B) OPEN DOOR TRAVEL LIMIT

7PRESS and HOLD until door is FULLY OPEN then RELEASE

MRA	—	+

Watch door move

NOTE: You can start and stop door

movement using either buttons until door is in correct open or closed position.

8

PRESS and

RELEASE

OGRAM
PR		—
	SET	—
	SET

Door Limits are set.

Both LEDs flash Blue

and go OFF.

Continue with Step 9 SET FORCE.

12/2010

9SET FORCE Force is set automatically with first full CLOSE/OPEN door operation.

On Wall Console

PRESS and RELEASE

DOOR CLOSES

10

On Wall Console

PRESS and RELEASE

DOOR OPENS

NOTICE

Perform a successful CONTACT REVERSE TEST and then continue with remote programming.

NOTE: To reset LIMIT settings, repeat Steps 1-10.

7

Image 7

Contents

Operation and Maintenance Manual Prevention Potential HazardSafety Features Opener FeaturesTable of Contents Infrared Protection Function Important Installation InstructionsProgramming Limits & Force Both LEDs flash Blue Go OFF PressSee long Blue LED flashing Press and Hold until door is Fully Open then ReleaseTest AdjustmentSee both LEDs Flash Blue See both LEDs OFF Program Intellicode 2 Remote to PowerheadIntelliCode 1 remotes See round Blue LED come onSee long Purple LED flashing Genie IntelliCode 1 wireless keypadGenie IntelliCode 1 remote See oneReference Powerhead & Rail Assembled View Typical Sectional Door Installation Typical ONE Piece Door Installation On powerhead Overview of Powerhead ControlsProgramming Buttons location Simultaneously on Overview Remotes and OptionsHold Press both2010 IntelliCode Intellicode FeaturesUse this New IntelliCode 2 openersTransmitter Compliance Statement Maintenance & TroubleshootingDoor Balance Spring Tension Routine Monthly MaintenanceAdjustment Safe-T-Beam System Check Door balance Contact reverseShuttle ENGAGE/DISENGAGE Disconnect power to door openerReset OPEN/CLOSE Travel Limit Change Light BulbsControls door opener lights from inside garage Wire routingWall Console Overview Open and closes door from inside garageThis area left blank Remote Battery ReplacementChange Speed Setting Adjustment Guide Speed SettingsPowerhead LEDs Round LED Long LED Force Level LED indicator colors Adjustment Guide Force SettingsChange Force Setting Down Force settings within the available rangeTroubleshooting Guide Operation Powerhead LED Possible Problem Solution Opening Cover May Cause Electric Shock Disconnect power from opener prior to removing coverTrilo