Genie 3511035556 manual Sect 2-INSTALLATION, Determining header bracket location

SECT 2—INSTALLATION

NOTE: There are differences in installations depending on which type of door you have. These differences are explained throughout this section. Please note those steps which are applicable to your particular door.

REFER TO PAGES 2 & 3.

There are two basic types of residential garage doors. They are:

SECTIONAL DOORS—divided into a set of narrow panels (usually four) connected by hinges, so door can “bend” as it rides on a curved track.

1-PIECEDOORS—consist of one large

panel and swivel on large spring-loaded hinges on each side of door.

1.Determining header bracket location.

•Find center of door from side to side.

–Measure overall width of door. (example: 16 feet)

–Divide overall width by 2. (example: 16 ÷ 2 = 8 feet)

•Measure this distance from side of door and draw a pencil line vertically from the top of the door down approximately 1 foot. This is the centerline. Fig. 2-1.

–Continue marking centerline on wall above door from top of door up approximately 1 foot. Fig. 2-1.

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

TYPICAL TRACKLESS

CENTERLINE

15

garage door

floor

TYPICAL TRACK GUIDED

CENTERLINE

garage door

floor

Fig. 2-1

Sectional doors may have one torsion spring (as shown) or two springs (one on each side).

Some older doors may have extension springs.