Genie 3511035556 manual Sect 5 -LIGHT & Lens Installation

WALL CONTROL OPERATIONAL FEATURES FOR HELP- GENIECOMPANY.COM

1.Wall console. Fig. 4-5.

A. Vacation locking switch.

–Lock disable all controls after door closes..

–Unlock allows all controls to work normally.

NOTE: Carriage must stay in contact with “CLOSE” limit switch in order for the vacation locking switch to work.

B. Door control button.

–Opens and closes door from inside garage.

–Lights on shows system has power available and vacation switch is not locked.

–Lights out shows either power is not available or vacation locking switch is locked.

C. Independent light control.

–Turns operator lights on and off without moving door.

2.Wall Button

–Operates door from inside garage.

A

C B

Fig. 4-5

25

SECT 5 —LIGHT & LENS INSTALLATION

FOR HELP-1.800.354.3643

1. Install light bulbs.
• 2 bulbs.
–	No more than 60 watts each.
		bottom of lens cover hooks
–	Do Not use short neck bulbs.
		into slots in front plate

–Whenever possible, use bulbs rated for: Rough service

Vibration

Appliances

2.	Install lens.
	• Hook bottom hinges into slots at bottom of
	front plate. Fig. 5-1.	Fig. 5-1
	• Swing lens up over lights. Check for alignment
	between the screw holes in the Lens and those
	on the metal front plate.
	• Lens will be fastened with 2 pan head screws.
	([42] green parts bag). Fig. 5-2.
	DO NOT FASTEN YET! Wait until you have
	completed programming the Remote Controls.	pan head screws
		secure top of lens
		Fig. 5-2

[42]

#8 x 3/8" Pan head screw