Genie 3511035556 manual Attach door arms 23 For sectional doors, For 1-piece doors

INSTALLATION

OPEN YELLOW PARTS BAG

10.Attach door arms [23] and [26].

•For sectional doors.

–Connect short leg of curved arm to door bracket. Fig. 2-14.

–Use clevis pin [24] and cotter pin [25]. Fig. 2-14.

–Connect straight arm to carriage.

–Use clevis pin [24] and cotter pin [25].

–Overall length of arms together should be as short as possible, but must not be so short that they are vertical when the door is fully closed. Fig. 2-14.

a.Move carriage as necessary to adjust length.

b.Place bolts [27] and nuts [28] as far apart as possible. Fig. 2-14.

c.Tighten bolts and nuts.

•For 1-piece doors.

–Connect short leg of curved arm to carriage. Fig. 2-14.

–Use clevis pin [24] and cotter pin [25]. Fig. 2-14.

–Connect straight arm to door bracket.

–Use clevis pin [24] and cotter pin [25].

–Overall length of arms together should be as long as possible. Fig. 2-14.

a.Move carriage as necessary to adjust length.

b.Place bolts [27] and nuts [28] as close together as possible. Fig. 2-14.

c.Tighten bolts and nuts.

11.Adjust emergency release knob height.

•Knob should hang approximately 6 feet from the floor.

–adjust as necessary to clear vehicles yet maintain height where it can be

easily reached.

•Pull cord through lever until knob is at desired height.

•Tie a new knot at the lever.

•Cut off excess cord.

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

SECTIONAL DOOR
must be	21
some angle
off vertical.
clevis & cotter pin
—bolts/nuts (far apart as possible)
1-PIECE DOOR
clevis & cotter pin
—bolts/nuts (close as possible)
Fig. 2-14

[27]

3/8" Hex head bolt

[24]

Clevis pin

[28]

[25] 3/8" Nut

Cotter pin