Genie 3511035556 manual Sect 1-MAIN Assembly, Install coupler

SECT 1—MAIN ASSEMBLY

OPEN BLUE PARTS BAG

NOTE: 3-piece rail assembly is for doors up to

10 and including 7 feet 6 inches high. An extension for 8 feet doors is available.

1.Set power head so that front panel (with end of shaft and rail attachment flange) is facing up. Fig. 1-1.

NOTE: If you have this type Carriage Stop, skip Step 2. DO NOT install Bumber.

2.Install bumper [45].

•Peel protective paper from glue side of bumper.

•Stick bumper into position as shown. Fig. 1-1.

3.Install coupler [39].

•Place coupler over end of shaft.

•Turn it as needed until it engages with shaft. (It will drop down over end of shaft and will no longer turn freely. Fig. 1-1.

4.Set power head on its bottom. Fig. 1-4.

CAUTION

Drive screws can slide out of rail sections. Keep rail sections level until operator is fully assembled.

5.Attach 1-piece rail or “first” rail section[3A] of 3-piece rail to power head.

•(3-piece only)Select “first” rail section. (It has protective cardboard sleeve over end of screw.) Fig. 1-2.

•(3-piece only) Remove cardboard sleeve.

•Slide end of screw out about 5 inches. Fig. 1-3.

•Place bearing end of screw against coupler. Fig. 1-4.

•Turn screw until it engages with coupler.

•Slide rail section into rail attachment flange until holes in rail match up with holes

in flange.

•Secure “first” rail section with 2 bolts [4] and 2 nuts [5], hand tight only. Fig. 1-5.

•For 1-piece rail, skip to step 8.

[39][45]

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

coupler

serial no.

bumper

Fig. 1-1

Fig. 1-2

Fig. 1-3

Fig. 1-4

Coupler Rubber bumper