Apple G4 manual Install the ATA drive in the U-shaped bracket

5Install the ATA drive in the U-shaped bracket.

Note: The tinted screws illustrated below indicate the four low-profile screws that came in the computer’s accessory kit. The untinted screws show the screws that came with the new drive.

These two tabs will

bend inward as you tighten these two screws.

Attach an additional ATA drive (1" high) to the upper portion of the drive carrier by screwing it into position on its sides. Attach the two screws on this side first.

ATA drives that are 1" high are attached to the lower portion of the drive carrier from the bottom.

Position the hard disk drive on the drive carrier so that the ribbon cable connector and the power cord connector are accessible.

If you’re installing a drive in the lower part of the U-shaped bracket, use the low-profile screws to attach the bottom of the drive to the carrier.

60 Chapter 4