Allstar Products Group J3500, 3000, 3500-P owner manual Fastening Limit CAM to Chain

Page 12

C: INSTALLING THE OPERATOR

STEP 9: Consult the label on the rear panel of the Opener to determine its proper working voltage. Normally it will be marked for 115V, 60 cycle operation. (If it is an export model designed for 220V, 50 cycle operation, the label will clearly indicate this.) The Opener must be plugged into a properly grounded receptacle within 3 FT of the Power Unit. A GFI Type receptacle is recommended. Do not use 2-prong adapters and do not use extension cords for anything more than temporary hook-up and testing purposes. Receptacle wiring should be No. 14 or heavier, and must be in compliance with local building and electrical codes.

WARNING

DISCONNECT POWER AT FUSE BOX AND OPENER BEFORE WIRING PERMANENTLY TO PREVENT ELECTROCUTION.

WARNING

IMPROPER WIRING COULD CAUSE ELECTROCUTION OR DAMAGE TO CIRCUITRY. FOLLOW LOCAL BUILDING AND

If local codes require permanent wiring, a GFI type circuit breaker is

 

recommended to protect the line. Remove the Strain Relief Bushing and

 

withdraw the Line Cord from the rear of the Power Unit to expose the three

104380

insulated connectors. Cut the wire at the rubber jacket of the Line Cord and wire in permanently, employing proper wiring practices. Discard Strain Relief. It is not used with permanent wiring.

Step 10: Install a 60 watt Rough Service bulb firmly in the light socket. Light bulbs in Door Openers are subject to vibration during normal operation which may shorten their life spans. Rough Service bulbs, available at most hardware stores, are recommended. Fit Light Diffuser tabs into the panel slots as shown.

104381

106428

STEP 11: On most models, the Limit Cams are installed at the factory. If the Limit Cams have not been installed, fasten them to the Chain in the approximate positions illustrated above. Position the Switch Actuators as shown above.

FASTENING LIMIT CAM TO CHAIN

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Series Table of Contents Product Features Optional FeaturesComponent Identification Tools RequiredAssembly Instructions StepImportant Installation To Reduce the Risk of Severe Injury AdjustmentInstalling the Operator Do not Attempt AdjustmentMounting the Front Bracket One High ARC Rise High ARC Rise Horizontal LineMount Power Head to Ceiling Sectional Doors and One Piece Doors with TrackOne Piece Doors without Track Raise the opener Mounting straps in the slots closest to FrontDoor ARM Connection and Installation Connect the standard wall Push Button provided to Mount at least 5 FT from the floor to prevent small childrenFastening Limit CAM to Chain Auxiliary Equipment Photosystem Unit is Within the Limit Marks on the Door JambConnect the Photosystem as follows Final Installation Final Alignment and TestInstallation of Radio Controls Operating Parameters Check with Your Local Building Inspector FirstIf the Door is ONE SECOND, and then Begin Moving Upward104390 Operation and Adjustment Instructions Warni NGTesting the All-Clear Photosystem Security Switch is GarageOperator Wiring Diagram Wiring Auxiliary Equipment Series Connection Receiver FirstInstallation Checklist Troubleshooting Guide Symptom Probable CAUSE/SOLUTIONSolution Probable CauseAllstar Corporation Downingtown, PA
Top Page Image Contents