D: AUXILIARY EQUIPMENT 
INSTALLATION OF RADIO CONTROLS:
The following instructions detail installation of Allstar Model 9931 Radio Controls. For other Radio models, see instructions packaged with product.
104384
TRANSMITTER: To gain access to the Transmitter Coding Switches, remove the Battery Cover from the front of the Transmitter by sliding it toward the bottom of the Transmitter as illustrated.
104385
RECEIVER: The Receiver Coding Switches can be accessed by removing the small door from the back of the Receiver using a small screwdriver or knife.
104386
CODING BLOCK: Transmitter and Receiver Coding Switches are contained in identical Coding Blocks, consisting of nine small switches, labeled 1 - 9, each of which can be set in any of three positions, labeled +, 0, -
Setting The Coding Switches: When setting the Coding Switches THE FACTORY
NOTE: For security reasons, it is advisable NOT to set all the switches in the same position.
104387
PLASTIC 
PIN 
Mounting The Receiver: After setting the Coding Switches, mount the Receiver on the rear panel of the Opener by connecting it to Terminals 1, 2 and 3. A small Plastic Pin is provided to secure the other end of the Receiver to the panel. For proper operation, the Antenna Wire should be POINTED STRAIGHT DOWN toward the floor.
WARNING
TO PREVENT THE RISK OF PERSONAL INJURY, DAMAGE TO DOOR OR PROPERTY, ONLY OPERATE DOOR
After installing the Radio Controls, check their operation by moving approximately 35 FT away from the garage door and
pressing the Transmitter Button. Operation at this distance should be reliable.
If the Transmitter doesn't activate door operation, check that all Coding Switches are set identically. If the operational distance is inadequate, try moving the position of the Transmitter in the car. If the distance is still inadequate, try bending the Antenna Wire to a different angle. If the distance is still inadequate, replace the Battery with a standard 9- Volt “transistor radio” Battery (NEDA 1604). The Battery is located in the front compartment next to the Coding Switches.
The Transmitter may be hand held if desired by removing the Visor Clip from the rear of the Case as illustrated. Place your finger in the loop at the top of the visor, and your thumb on the top edge of the Transmitter. Push down with your thumb and pull up with your finger. Clip will release and pull out easily.
CONTROLS WHEN DOOR IS IN CLEAR VIEW. KEEP REMOTE CONTROL AWAY FROM CHILDREN IN SECURE AREA.
104388
15