Allstar Products Group 3500-P, J3500, 3000 Installing the Operator, Do not Attempt Adjustment

C:INSTALLING THE OPERATOR

IMPORTANT!

IDENTIFY YOUR DOOR TYPE FROM THOSE ILLUSTRATED BELOW AND FOLLOW

INSTRUCTIONS FOR THAT TYPE OF DOOR

104367

SECTIONAL DOOR	ONE PIECE DOOR
CURVED TRACK	HORIZONTAL TRACK
	JAMB HARDWARE

HIGH ARC OF
	HIGH ARC OF
DOOR TRAVEL
	DOOR TRAVEL

	TRACK
	TRACK
DOOR	DOOR

ONE PIECE DOOR NO TRACK JAMB HARDWARE

HIGH ARC OF

DOOR TRAVEL

DOOR

JAMB

HARD-

WARE

104368

ONE PIECE DOOR NO TRACK PIVOT HARDWARE

HIGH ARC OF

DOOR TRAVEL

DOOR

PIVOT

FOR THESE TYPES OF DOORS USE 1/3 HP

MODEL 3000 OR 1/2 HP MODEL 3500 OR 3500-P.

USE 7 FT, 8 FT OR 10 FT RAIL

(MATCH DOOR HEIGHT)

FOR THESE TYPES OF DOORS USE 1/3 HP MODEL

J3000 OR 1/2 HP MODEL J3500.

USE 7J RAIL

(FOR DOOR HEIGHT UP TO 8 FT)

	SPRINGS, PULLEYS, CABLES AND MOUNTING HARDWARE USED TO
	BALANCE YOUR GARAGE DOOR ARE UNDER EXTREME TENSION AT ALL
WARNING	TIMES AND CAN CAUSE SEVERE INJURY OR DEATH IF DISTURBED.
	DO NOT ATTEMPT ADJUSTMENT.

VERTICAL

HORIZONTAL CENTERLINE LINE

STEP 1: Mounting the Front Bracket — Sectional Doors and One- Piece Doors with Track (For One-Piece Doors without track see Step 1A, next): Mark a vertical centerline on the header above the door. By manually raising the door, determine the high arc of the door’s travel (see illustration, above left) and using a level, transfer this measurement to the header (see illustration at left). Draw a horizontal line, crossing the previously drawn centerline, at this point. Install the Front Mounting Bracket securely wit lag screws as shown on the following page. If necessary, reinforce the header with steel angle iron or wood to ensure a secure mount.

104369

	FRONT MOUNTING BRACKET MUST BE INSTALLED TO A STRUCTURAL SUPPORT
	(STUD) ON THE HEADER WALL. FAILURE TO DO SO COULD CAUSE SENSING
WARNING	SYSTEM TO MALFUNCTION, RESULTING IN ENTRAPMENT, INJURY OR DEATH.
	REINFORCE HEADER IF NECESSARY USING A 2 x 6 AND LAG SCREWS
	(NOT PROVIDED).

7