Westell Technologies 2100 manual Router Installation via USB, Connection via USB

User Guide WireSpeed Dual Connect NAT Router

5.4.2 Router Installation via USB

!

NOTE: The USB installation will not function for Macintosh computers. Macintosh computers must install the Router via Ethernet connection. See section 5.4.1.

~

1.Connect the power supply cord to the power connector marked 12V on the rear panel of the Router. Plug the other end of the power supply cord into a surge-protected AC wall socket.

2.Connect the DSL phone cable from the connector marked on the rear panel of the Router marked to the DSL-equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the phone cord that was provided with the Router kit.

3.Connect the USB cable from the USB connector marked on the rear panel of the Router to the USB port on the PC.

Congratulations! You have completed the USB hardware installation for your Dual Connect NAT Router. Refer to your Internet service provider’s instructions for installing subscriber software and connecting to the Internet. You must now go to Section 6 to begin the USB drivers software installation.

Figure 2. Connection via USB

030-300198 Rev. D 7 March 2003